LT3-00032-2-A - DDKS Industries, hydraulic components distributor

TECHNICAL CHARACTERISTICS
TECHNICAL
CHARACTERISTICS
specification term Goldcup 24 Goldcup 30
•displacement at max. angle in 3 /rev. 24.6 30.6
cm 3 /rev. 403 501,4
•pressure, continuous psi 5000 5000
bar 345 345
•speed max. continuous at full stroke rpm 2100 1) 1800
consult DENISON HYDRAULICS for higher speeds
•flow, ports A or B at 1500 rpm gpm 159.7 198.7
theo. at max. displ. Lpm 604,6 752,1
at 1800 rpm gpm 191.7 238.4
Lpm 725,5 902,5
at 2100 rpm gpm 223.6 -
Lpm 846 -
P24P
P30P
•aux. pump theor. displ. / rev. 2) in 3 /rev 2.81 2.81
cc/rev 46,1 46,1
P24S 3) P30S 3)
in 3 /rev 1.05 1.05
cc/rev 17,2 17,2
P24P
P30P
•flow, auxiliary pump at 1500 rpm gpm 18.2 18.2
internal - theo. flow
at 1800 rpm
Lpm
gpm
69,1
21.9
69,1
21.9
Lpm 82,9 82,9
at 2100 rpm gpm 25.5 -
Lpm 96,7 -
P24S 3) P30S 3)
at 1500 rpm gpm 6.5 6.5
Lpm 24,5 24,5
at 1800 rpm gpm 7.8 7.8
Lpm 29,5 29,5
P24S 3) P30S 3)
•flow, auxiliary pump at 1500 rpm 4) gpm 18.2 18.2
external - standard T6C-025 Lpm 69,1 69,1
at 1800 rpm gpm 21.9 21.9
Lpm 82,9 82,9
P24P P24S P30P P30S
•aux. pump servo pressure range psi 340-640 490-790 360-772 490-902
varies upward with pressure in bar 23-44 34-54 25-53 34-62
port A or B,
based on 0 psi 0 bar case pressure
P24P P24S P30P P30S
•Aux. pump replenishing pressure psi 180-220 330-370 180-220 330-370
based on 0 psi 0 bar case pressure bar 12-15 23-26 12-15 23-26
•mounting SAE 177-4 177-4
(“F” 4- bolt) (“F” 4- bolt)
•shaft-spline or keyed SAE 50-1,4 50-1,4
(“F”)
(“F”)
•weight P24P P24S P30P P30S
lbs 690 755 710 787
kg 313 342 322 357
1)
On R & O oils rust and oxidation inhibitor.
2)
Standard, other sizes available.
3)
Internal cartridge provides servo flow and must be supercharged from external
replenishing flow. from external auxiliary pump
4)
Any SAE 82-2 or SAE 101-2 mounting pump may be used, with the corresponding
adapters.
3