LT3-00032-2-A - DDKS Industries, hydraulic components distributor
LT3-00032-2-A - DDKS Industries, hydraulic components distributor
LT3-00032-2-A - DDKS Industries, hydraulic components distributor
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
ASSEMBLY PROCEDURE<br />
CLEANING AND INSPECTION<br />
All parts must be inspected and be free of material defects, dirt, scratches or any<br />
foreign material.<br />
All parts must be cleaned with a suitable cleaning solvent and all holes and passages<br />
blown out with dry, clean, compressed air.<br />
After cleaning and inspection, all parts must be covered with a light film of oil and protected<br />
from dirt and moisture. Excessive handling of internal parts should be avoided<br />
prior to assembly.<br />
During assembly, lapped and ground surfaces must be lubricated with clean oil and<br />
protected from nicks or surface damage.<br />
DRIVE SHAFT AND BEARING<br />
ASSEMBLY<br />
See figure 1. Slide the bearing (2) over the short end of the shaft and seat against the<br />
shoulder. Support only the inner race of the bearing and press on the long end of the<br />
shaft, to install bearing.<br />
Do not use excessive force. Use extreme care passing the ring over the seal surface.<br />
Install the retaining ring (3) in the groove. Be sure that the ring is fully seated.<br />
2<br />
3<br />
1<br />
4<br />
#3 SHAFT #2 SHAFT<br />
PARTS LIST FOR FIGURE 1<br />
S23-12474 DRIVE SHAFT #3 ASSEMBLY SPLINED<br />
S23-12475 DRIVE SHAFT #2 ASSEMBLY KEYED<br />
quantity<br />
item description part no. #3 #2<br />
1 #3 spline shaft 033-91139 1 -<br />
#2 keyed shaft 033-91140 - 1<br />
2 shaft bearing 230-82213 1 1<br />
3 retaining ring 033-71712 1 1<br />
4 square key 033-71910 - 1<br />
FIGURE 1<br />
ROCKER CAM, PISTONS-SHOES &<br />
RETAINER<br />
FIGURE 2<br />
15