Installation and System Requirements - O&O Software

Task Tray Control
If desired, an icon can be created in the task tray which displays the present defrag status.
By double-clicking, you can display the Status Monitor.
By right-clicking you can control the defragmentation without opening the user interface.
Under Settings/General/Task Tray Control you can assign icons to various functions.
Make advanced controls available to logged on users: You can allow the registered user
to stop or fully end a defragmentation.
Deactivating this function means the user can only monitor the defragmentation but not
control it.
Set Hibernation Mode
If you need to have all your computer’s performance available at a certain time, you can
right-click above the taskbar icon and enable Hibernation Mode. This will stop all defragmentation
jobs or make sure they will not be started.
Settings
Check Drives before Defragmentation (chkdsk)
You can have O&O Defrag check the integrity of your drives before a defragmentation. If
O&O Defrag finds an error on one of your drives, the defragmentation will not be run (for
safety reasons). This check is like the Windows chkdsk function but errors that are found will
not be corrected. These will have to be corrected manually using the chkdsk function.
User's Guide for O&O Defrag 11
User Interface (GUI) l 25