Operation Manual Pressure Washer - DeVilbiss Air Power Company

1. To Assemble Quick Connect
Grommets:
a. Squeeze grommet and place
into hole, fitting groove to
rim.
ASSEMBLY INSTRUCTIONS
4. Connect wand to gun. Tighten
securely.
5. Attach high pressure hose to
gun. Tighten securely.
b. Push grommet into place.
c. Repeat steps until all
grommets are assembled.
2. To Assemble Quick Connect
Nozzles:
a. Remove
five
colored
quick
connect
nozzles
from
plastic bag
and insert
them into correct grommet.
NOTE: Nozzles are color
coded to match colored
6. To Assemble Accessories
Panel
a. Remove top screws on
handle assembly.
b. Loosen bottom screws on
handle assembly.
c. Place grooves in accessories
panel assembly onto screws
and slide panel assembly
into place.
d. Place screws (removed
earlier) into the top holes and
secure accessories panel
assembly to handles. Do not
overtighten.
Remove
Loosen
Screws
nozzles on panel. 7. Add engine oil (supplied)
to engine. Refer to Engine
Owners Manual supplied by
engine manufacturer for correct
procedure.
NOTE: There will be a slight amount
of oil in the engine from factory
testing.
3. Place handle assembly onto
frame, depress the snap buttons,
and slide the handle assembly
onto the frame until snap buttons
snap into place.
NOTE: The pump on this unit is
maintenance free and requires no oil,
if there is a problem with the pump
contact an Authorized Service Center.
7- ENG A12496