here - Snap-on Equipment

Installation and Operation
3. Connect blue (low side) service hose between low port
on unit and previously installed tank adapter.
4. Open blue (liquid) tank valve. Close red (vapor) tank
valve, red (high side) service hose coupler, and high side
panel valve.
5. Open blue service hose coupler, and low side valve on
control panel.
6. Plug the power cord into a properly grounded supply line.
Refer to the ID Plate on the back of your Kool Kare unit
for proper supply voltage.
7. Turn on the power switch. The following screens display:
— The Kool Kare Welcome screen,
— The Software Version screen,
— The Adjust Contrast screen–Adjust or Skip, and
— The Recycle screen.
8. Select NO. The Vacuum screen displays.
9. Select YES. The Vacuum Time screen displays.
10. Press UP key twice until Minutes field displays 10.
11. Press ENTER. The Hold Vacuum screen displays.
12. Press ENTER. The Charging screen displays.
13. Select NO. The Connection Check screen displays.
14. Select CONTINUE. The following messages display:
I'M CHECKING FOR PRESSURE IN VEHICLE BEFORE
PULLING VACUUM!
SETTING UP FOR VACUUM MODE
PLEASE WAIT!
PULLING VACUUM ON VEHICLE.
3 The last message also displays the number of minutes
remaining for the vacuum cycle.
15. The evacuation procedure runs for ten minutes. Your
Kool Kare unit beeps twice when the procedure is
completed. The final screen in the cycle displays with
the following message:
COMPLETED!
2-2