ToneLab LE's manual - Vox

HINT: If you want to replicate the sound of the original amp, set [VR GAIN] to the maximum setting on
vintage-type models that do not have a master volume control (i.e., AC15, AC15TB, AC30,
AC30TB, UK BLUES, UK 68P, BLACK 2x12, TWEED 1x12, and TWEED 4x10). For moderntype
amps that have a master volume control, adjust [VR GAIN] in the same way that you would
on the original amp. When the [VR GAIN] setting is low, preamp-type distortion will occur. As
you raise the [VR GAIN] setting, the pre-amp will begin loading the Valve Reactor to cause clipping,
and the warmth and distortion of the Valve Reactor will be added.
14. ToneLab LE provides a PEDAL effect that is placed before the amp, and MODULATION,
DELAY, and REVERB effects that are placed after the cabinet.
For example if you want to use the PEDAL effect TREBLE BOOST, turn the PEDAL selector
to select TREBLE BOOST. The PEDAL parameter LED of the edit section will blink, indicating
the parameter line (the region listing the parameter names). Also, the LEDs below the
value knobs will light, indicating the location of the knobs that you can use to control TRE-
BLE BOOST. Now turn value knobs 1, 2, and 3 to adjust DRIVE, LEVEL, and TONE respectively.
You can edit other effects using the same procedure.
HINT: Some effect settings may cause unwanted distortion (if there is such a thing!!). If this happens,
lower the PROG LVL. (p.25)
8