ToneLab LE's manual - Vox
ToneLab LE's manual - Vox
ToneLab LE's manual - Vox
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Setup<br />
NOTE: You must turn off the power of all your equipment before you make connections. If you ignore<br />
this warning, you may damage your speaker system or experience malfunctions!<br />
BASIC CONNECTIONS<br />
Introduction<br />
Panel Tour<br />
Setup<br />
Headphones<br />
to your mixer/recorder<br />
or guitar amp<br />
LINE/AMP<br />
External effect processor<br />
AC/AC<br />
power supply<br />
Guitar<br />
Playing<br />
PHONES L/MONO R<br />
OUTPUT<br />
INPUT<br />
RETURN SEND<br />
~AC9V<br />
to an AC<br />
outlet<br />
Creating<br />
and Storing<br />
<strong>ToneLab</strong> LE<br />
1. Use audio cables to connect <strong>ToneLab</strong> LE’s OUTPUT L/MONO and R jacks (7.6) to a mixer/<br />
recorder or guitar amp. If desired, you can also connect an external effect processor. To do<br />
this simply connect SEND to the input of your external processor, and RETURN to the output<br />
of your external processor.<br />
HINT: If you’re making connections in mono, use the OUTPUT L/MONO jack. However to take the fullest<br />
advantage of <strong>ToneLab</strong> LE’s sound, we strongly recommend that you use stereo connections.<br />
If you are using headphones, plug them into the HEADPHONES jack (7.8).<br />
NOTE: Signal from the OUTPUT jack(s) will still be heard even if headphones are plugged in. If you<br />
only want to hear signal from headphones you must disconnect any cables from the Output<br />
jacks or turn off or lower any equipment <strong>ToneLab</strong> LE is connected to.<br />
2. Turn the LEVEL knob (7.7) located on the rear panel of <strong>ToneLab</strong> LE all the way toward the<br />
left (as seen from the rear), setting the volume to 0.<br />
3. Connect the included AC/AC power supply to the rear panel AC9V power supply jack (7.3),<br />
and then connect the plug to an AC outlet.<br />
4. Plug your guitar into the rear panel INPUT jack (7.4).<br />
5. Turn down the volume of your amp or mixer so you don’t hear crackles or pops when the<br />
power is turned on. Then turn on the STANDBY switch (7.2) to turn on the power.<br />
6. If you have connected <strong>ToneLab</strong> LE to a mixer/recorder, press the AMP/LINE button, then use<br />
value knob 1 or the ▲, ▼ buttons to select “Ln1” or “Ln2” (LINE). If you’ve connected <strong>ToneLab</strong><br />
LE to a guitar amp, select one from “AP1”–“AP3” (AMP).<br />
HINT: If you have connected only the headphones, select “Ln1” or “Ln2” for the AMP/LINE setting.<br />
19