ToneLab LE's manual - Vox

4
SETTING/GLOBAL SECTION
4.1 EXP-CTL-CHAIN button
Use this button to make expression pedal or control switch settings. Alternatively, use this
button to change the chain setting, that is, the connection order of the modulation, delay,
and reverb effects.
Use value knobs 1–3 to edit the expression pedal target parameter and the control range
parameter.
Use value knobs 4–5 to edit the control switch target parameter and the FACTOR parameter.
Use value knob 6 to make the chain setting.
You can also use the ▲, ▼ buttons to edit the value.
If this button indicator lights up while you’re editing, it indicates that the expression pedal
Quick Assign function is available.
HINT: [Quick Assign] If the EXP-CTL-CHAIN button is lit while you are editing an effect, you can use
the expression pedal Quick Assign function. To assign the parameter shown in the name display
to an expression pedal, hold down the EXP-CTL-CHAIN button for one second. When the
assignment is complete, the name display will indicate COMPLETE.
4.2 ▲, ▼ buttons
Use these to edit the value of parameters.
4.3 √, ® buttons
Use these to select the parameter you want to edit, or to edit the program name.
4.4 [AMP/LINE] button
Use this button to make the ToneLab LE output settings. If you selected “Ln2,” you can use a
three-band equalizer to adjust tonal characteristics of the amp models.
4.5 RENAME button
Use this to change the program name (p.26).
Use the √, ® buttons to move between spaces (characters) in the display, and use value
knob 6 or the ▲, ▼ buttons to change the character at that space.
4.6 GLOBAL button
Use this button to make pedal, MIDI, or digital output settings.
Press the GLOBAL button and use the √, ® buttons to move through the menu items in the
order shown below. After you have selected a menu item, use value knob 6 or the ▲, ▼ buttons
to adjust the value.
Introduction
Panel Tour
Setup
Playing
Creating
and Storing
EXP INIT: Specifies the expression pedal operation during Program Change (p.48)
MIDI CH: Specifies the MIDI channel (p.51)
PCHG OUT: Specifies the program change message output setting (p.51)
CCHG I/O: Specifies the control change message input/output setting (p.52)
SYEX OUT: Specifies the system exclusive message output setting (p.52)
DUMP CUR: Dumps the current program data from the MIDI OUT connector (p.53)
DUMP ALL: Dumps all of ToneLab LE’s data from the MIDI OUT connector (p.53)
DOUT LVL: Specifies the digital output level. (p.20)
4.7 WRITE button
Use this when you want to save the settings you’ve created (p.26).
4.8 EXIT/TUNE button
Use this to abort a program-write operation or to cancel a GLOBAL setting.
By pressing and holding this button for a longer time, you can activate/cancel the Key Lock
function, which disables operation of the buttons, selectors, and knobs (p.23).
By pressing this button while the name display is indicating a program name, you can activate
the tuner.
15