ToneLab LE's manual - Vox
ToneLab LE's manual - Vox
ToneLab LE's manual - Vox
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
AN OVERVIEW OF TONELAB LE<br />
Let’s talk about how <strong>ToneLab</strong> LE is structured.<br />
SIGNAL ROUTE<br />
When you plug into <strong>ToneLab</strong> LE the signal passes through the following stages.<br />
You might want to glance at the explanations in “A Guitarist’s Guided Panel Tour” (p.12)<br />
while you read this section.<br />
Introduction<br />
Panel Tour<br />
Setup<br />
INSERT<br />
EFFECT<br />
PEDAL<br />
EFFECT<br />
AMP MODEL<br />
16 TYPE<br />
PRE AMP<br />
VALVE POWER REACTOR AMP<br />
POWER CLASS AAMP<br />
PRE AMP CLASS A<br />
CLASS AB CH<br />
GAIN VR GAIN CLASS AB VOLUME CH<br />
GAIN VR GAIN<br />
VOLUME<br />
CABINET<br />
MODEL<br />
11 TYPE<br />
VOLUME<br />
PEDAL<br />
EFFECT<br />
MODULATION<br />
DELAY<br />
REVERB<br />
OUTPUT<br />
SELECT<br />
Playing<br />
MODES<br />
<strong>ToneLab</strong> LE has a Program Select mode (where you can switch programs) and an Effect<br />
On/Off mode (where you can switch individual effects on/off). To switch between these<br />
modes, simply press the BANKUP (FX ON/OFF) switch which can be done even while you<br />
are performing.<br />
Creating<br />
and Storing<br />
AMP AND EFFECT SETTINGS (EDIT)<br />
The five model selectors, six value knobs, and various buttons let you edit the amp and<br />
effect settings directly and intuitively. You can use the CHAIN function to change the order in<br />
which the modulation, delay, and reverb effects are connected. Use the EXP-CTL-CHAIN<br />
button to set the CHAIN function.<br />
REALTIME EXPRESSION PEDAL AND CONTROL SWITCH<br />
You can use the expression pedal and control switch to control wah, volume, or effect<br />
parameters with your feet. Use the EXP-CTL-CHAIN button to select the parameters you<br />
wish to control.<br />
SAVING A PROGRAM<br />
By using the WRITE button, all settings you make can be saved as a “program.” When doing<br />
so, you should use the RENAME button to give the program a new name. Once you’ve saved<br />
a program, you can use the program select switches to recall it instantly (in Program Select<br />
mode).<br />
MIDI AND OUTPUT DESTINATION SETTINGS<br />
The GLOBAL button lets you make MIDI-related settings and specify the operation of the pedal<br />
for Program Change. The settings you make here are automatically saved within <strong>ToneLab</strong> LE<br />
so there’s no need to perform the WRITE operation.<br />
11