ToneLab SE Owner's manual - Vox

SETTING THE MIDI CHANNEL (GLOBAL “MIDI CH”)
In order to exchange data with an external MIDI device, ToneLabSE’s MIDI channel
must match the MIDI channel of your external MIDI device. Here’s how to set
the MIDI channel.
1. Press the GLOBAL button (3.4).
2. The name display (3.8) will show “MIDI CH.” If a different parameter is
selected, press the √, ® buttons (3.2) to change the display.
3. Use the value knob 3 (2.2) or the ▲, ▼ buttons (3.1) to set ToneLabSE’s MIDI
channel.
4. Set the MIDI channel of your connected external MIDI device.
For details on how to set the MIDI channel of your external MIDI device, refer
to its owner’s manual.
PROGRAM CHANGE (GLOBAL “PCHG OUT”)
When you switch programs on ToneLabSE, a program change message is transmitted
from the MIDI OUT jack, causing an external MIDI device to switch programs.
Similarly, when ToneLabSE receives a program change message, its
program will switch automatically. Here’s how you can specify whether a program
change message will be transmitted from the MIDI OUT jack when you switch programs
on ToneLabSE.
NOTE: Program change numbers not used by ToneLabSE will be ignored. For
details on the range of program change numbers used by ToneLabSE, refer to End
of this manual.
1. Press the GLOBAL button (3.4).
2. Press the √, ® buttons (3.2) to make the name display (3.8) show “PCHG
OUT.”
3. Specify whether program change messages will be transmitted. Use value
knob 6 (2.2) or the ▲, ▼ buttons (3.1) to make the desired setting.
“OFF”: Program change messages will not be transmitted.
“On”: Program change messages will be transmitted.
CONTROL CHANGE (GLOBAL “CCHG I/O”)
When you operate the EXPRESSION pedal 1, Expression pedal 2, or Control pedal of
the ToneLabSE, control change messages will be transmitted. This means that functions
for the corresponding control change numbers on an external MIDI device can
be controlled in realtime.
Similarly, when ToneLabSE receives control change messages from an external MIDI
device, it will be controlled in the same way as if its own foot controller were operated.
For a list of the functions that can be controlled from an external MIDI device, refer to
step 4.
Here you can specify whether ToneLabSE will transmit and receive control change
messages.
60