ToneLab SE Owner's manual - Vox
ToneLab SE Owner's manual - Vox
ToneLab SE Owner's manual - Vox
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Setup<br />
NOTE: You must turn off the power of all your equipment before you make connections.<br />
If you ignore this warning, you may damage your speaker system or experience<br />
malfunctions!<br />
Introduction<br />
Panel Tour<br />
OUTPUT <strong>SE</strong>TTINGS<br />
Here’s how to specify whether you’re connecting <strong>ToneLab</strong><strong>SE</strong> to a guitar amp or to<br />
a mixer/recorder.<br />
1. Press the GLOBAL button, and use the √, ® buttons to make the display read<br />
“OUT <strong>SE</strong>L.”<br />
2. Use value knob 6 or the ▲, ▼ buttons to set the value.<br />
When connecting to a guitar amp<br />
When connecting to a mixer/recorder<br />
Setup<br />
Playing<br />
Creating<br />
and Storing<br />
NOTE: With the factory settings, “AP” is selected.<br />
BASIC CONNECTIONS<br />
1. Use audio cables to connect <strong>ToneLab</strong><strong>SE</strong>’s OUTPUT L/MONO and R jacks<br />
(11.4) to a mixer/recorder or guitar amp (p.13, 14). If desired, you can also<br />
connect an external effect processor. To do this simply connect <strong>SE</strong>ND to the<br />
input of your external processor, and RETURN to the output of your external<br />
processor.<br />
NOTE: If you’re making connections in mono, use the OUTPUT L/MONO jack.<br />
However to take the fullest advantage of <strong>ToneLab</strong><strong>SE</strong>’s sound, we strongly recommend<br />
that you use stereo connections.<br />
If you are using headphones, plug them into the PHONES jack (11.5).<br />
NOTE: Signal from the OUTPUT jack(s) will still be heard even if headphones are<br />
plugged in. If you only want to hear signal from headphones you must disconnect<br />
any cables from the Output jacks or turn off or lower any equipment <strong>ToneLab</strong><strong>SE</strong> is<br />
connected to.<br />
2. Turn the LEVEL knob (11.3) located on the rear panel of <strong>ToneLab</strong><strong>SE</strong> all the<br />
way toward the left (as seen from the rear), setting the volume to 0.<br />
3. Connect the included AC/AC power supply to the rear panel AC9V power supply<br />
jack (10.2), and then connect the plug to an AC outlet.<br />
4. Plug your guitar into the rear panel INPUT jack (11.1).<br />
5. Turn down the volume of your amp or mixer so you don’t hear crackles or pops<br />
when the power is turned on. Then turn on the STANDBY switch (10.1) to turn<br />
on the power.<br />
13