specs

a. Provide all metering equipment as required and shown on the drawings.
b. Meter Location: As indicated on the drawings and per the owner's direction.
5. Transformer Pad:
a. Provided by contractor in accordance with the power company's requirements.
b. Refer to the architectural site plan for the exact location.
3.08 INSPECTION OF SITE
A. Site Visit
1. Before submitting a bid, all bidders shall carefully examine the drawings and specifications,
and visit the site.
2. Bidders shall fully inform themselves in detail as to all existing conditions, limitations,
available clearances; shall thoroughly check all obstructions which are to be removed or
relocated to permit installation of the new equipment and facilities; and shall include in their
proposals a sum to cover the cost of all contingencies and work as required under the
drawings and specifications included in the Contract.
B. Failure on the part of any bidder and/or Contractor to familiarize himself with all existing conditions as
may be encountered or enumerated above will not be considered sufficient justification to request or
obtain any extra compensation over and above the Contract Price.
3.09 PROTECTION OF EQUIPMENT
A. Do not deliver equipment to jobsite until progress of construction has reached the state where
equipment is actually needed, or until building is closed in enough to protect equipment from the
weather. Equipment allowed to stand in weather will be rejected, and Contractor is obligated to
furnish new equipment of a like kind.
B. Adequately protect equipment (including all Owner-furnished items) from damage after delivery to job.
Cover with heavy cloth or other suitable material as required to protect from damage.
C. Equipment which has been marred, bent, etc., by construction activities will be rejected. Replace with
new equipment as specified.
3.10 RECORD DRAWINGS
A. Obtain, at Contractor's expense, a set of white prints and keep these on jobsite during construction.
During course of construction, mark on these prints any changes which are made, noting particularly
locations of those items which will need to be located for servicing.
B. At completion of job, obtain (at Contractor's expense) a set of "washoff" erasable mylar sepias and
incorporate all changes noted on the work prints. This must be done by a skilled draftsman. Mark
each sheet "Record Drawings", with date, and deliver to Architect.
3.11 FINAL TESTS
A. Upon completion of the work, test the individual systems, including all feeders, branches, outlets,
lighting, motors, apparatus, and appliances.
B. Provide all instruments, labor and materials required by Architect for any essential intermediate and
final tests.
C. Tests shall indicate full compliance with specifications, drawings and applicable codes.
D. The contractor shall assist and coordinate pre-function checklist, startup and system
functional testing with Commissioning Agent. Coordinate retesting as necessary
until satisfactory performance is verified.
3.12 INSPECTION
A. Entire installation subject to Engineer's inspection, final approval and acceptance.
B. Any corrections to the installed work shall be at the Contractor's expense.
END OF SECTION
Cinemark 16000 - 10 General Conditions for Electrical Work
South Napa Century Center XD 12 EnviroDesign, Inc., Bid Issue 7-7-11