specs

Section 11400
Page 2
1. Forest Stewardship Council (FSC): Provide letter of certification signed by lumber supplier. Indicate
compliance with FSC "Principles for Natural Forest Management" and identify certifying organization.
a. Submit FSC certification numbers; identify each certified product on a line-item basis.
G. Submit copies of invoices for all wood materials identifying material costs not including labor. Invoices for
FSC certified products shall identify FSC chain of custody (COC) number.
1.04 SITE DIMENSIONS
A. Dimensions shown on drawings or listed in the specifications are to be considered as a guide. It is the
responsibility of this Section to check dimensions on the job site and to coordinate adjustments that may be
necessary.
B. If such adjustments or changes appear to affect the initial contract intent or conditions, immediately notify the
Cinemark's Consultant.
1.05 DELIVERY OF EQUIPMENT
A. The General Contractor will coordinate the delivery and installation of the Equipment, and the related work of
other Sections.
1.06 COOPERATION
A. Supply to other Sections in sufficient time services, articles or equipment which requires building-in or
overlapping coordination. Also notify other Sections regarding exact locations for openings, chases, anchors
and other fittings required for the Equipment.
1.07 CERTIFICATES OF APPROVAL
A. Electrical equipment must conform to the requirements of the local Electrical Code. If the item specified is not
approved, or if components are not so approved, it is the responsibility of this Section to obtain, at no extra
cost to the Cinemark USA, the necessary approval from local authorities. Attach to each item of equipment
which requires it, a certificate or label of approval.
1.08 PRODUCT HANDLING
A. Protect the materials of this Section before, during and after installation, and protect the installed work and
materials of others.
PART 2 - PRODUCTS
2.01 GENERAL
A. Equipment supplied under this Section shall be made of the best grade materials, and shall be in strict
accordance with the drawings and specifications.
B. It is the responsibility of this Section to reconcile electrical and mechanical services and check locations of
roughed-in work. Deviations or inadequacies are to be brought to the attention of the Cinemark USA's
Consultant so that corrective measures, if necessary, can be made prior to equipment installation.
2.02 MATERIALS
A. Unless otherwise specified in the itemized List of Equipment, materials to be used in the fabrication of
equipment by this Section shall be as follows:
1. Stainless Steel: type 304, No. 4 finish one side, free from pits and imperfections, Gauges refer to U.S.
Standard.
2. Laminated Plastic: 1/16" in. thick for face and edges of panels or surfaces being clad. Where plywood or
MDF panels or surfaces are being clad, apply manufacturer's plastic backing sheet. Plywood shall be
minimum 5-ply, with veneer or solid lumber core, S2S; particle board shall be AWI with smooth dense
surface, 3/4 in. thick. Vertical surfaces exposed to public to be plastic laminate. Interior surfaces and
other vertical external surfaces to be Melamine.
3. Millwork panels or surfaces:
a. Sustainably Harvested Wood: Material shall be accredited by the Forest Stewardship Council
b. Provide products with no added urea formaldehyde.
4. Engineered Wood Products: Provide products with no added urea formaldehyde.
5. Sealant shall be Dow Silastic or GE #SCS-1600, clear or metallic gray. Meet VOC SCAQMD Rule 1168
identified in Section 01352
NAPA CENTURY CENTER XD 12
#165582