specs

PART 1 - GENERAL
SECTION 10260
PROTECTIVE WALLCOVERINGS
1.01 SCOPE
A. Provide Corner Guards where shown on the Drawings, as specified herein, and as needed for a complete
and proper installation. Corner guards should be in the scope of the Vinyl Wallcovering subcontractor.
B. Work, items and requirements specified elsewhere that apply and/or relate to this Section include:
1. Miscellaneous Metals - Section 05500
2. Wall coverings - Section 09950
1.02 SUBMITTALS
A. Comply with pertinent provisions of Section 01340
B. Submit 2 - 12" long samples of each finish, color and style selected.
C. Recycled Content:
1. Indicate recycled content; indicate percentage of pre-consumer and post-consumer recycled content
per unit of product.
2. Indicate material cost of product less labor included in project.
3. If recycled content product is part of an assembly, indicate the percentage of recycled content
product in the assembly by weight.
1.03 QUALITY ASSURANCE
A. Use adequate numbers of skilled workman who are thoroughly trained and experienced in the necessary
crafts and who are completely familiar with the specified requirements and the methods needed for proper
performance of the work of this Section.
PART 2 - PRODUCTS
2.01 CORNER GUARDS
A. Where called for on the Drawings, provide Korgard Wall Protection #G-815 (BLACK). 1 1/2”x 1 1/2"
as corner guards in the arrangements shown on the Drawings, and as manufactured by Koroseal Wall
Protection Systems. Install in 8’-0” & 12’-0” lengths, as shown on drawings. Contact Stacie Schueler
with Koroseal Interior Products Group 214.284.6421 NO SUBSTITUTIONS.
B. Where called on the Drawings, provide Koroseal Wall Protection Systems, Korogard standard 90 degree
angle 16 gauge stainless steel with #4 satin finish, 1 ½” x 1 ½” as corner guards in the arrangements
shown on the Drawings. Install in 8’-0” & 12’-0” lengths, as shown on drawings. Contact Stacie
Schueler with Koroseal Interior Products Group 214.284.6421 NO SUBSTITUTIONS
2.02 PREFINISHED WALL PANELS
A. Where called for on Drawings provide Korgard Wall Protection by In Pro Corp. Vinyl sheets with
transitions, Thickness to be .040” (1mm), color shall be “Black”. Contact Stacie Schueler with Koroseal
Interior Products Group 214.284.6421. NO SUBSTITUTIONS
PART 3 - EXECUTION
3.01 SURFACE CONDITIONS
A. Examine the areas and conditions under which work of this Section will be performed. Correct
conditions detrimental to timely and proper completion of the Work. Do not proceed until unsatisfactory
conditions are corrected.
3.02 INSTALLATION
A. Coordinate as required with other trades to assure proper and adequate provision in the work of those
trades for the work of this Section.
B. Install the work of the Section in strict accordance with the approved Shop Drawings and the
recommendations of the manufacturer as approved by the Architect, anchoring components firmly into
position in true alignment within a tolerance of one in 1000 vertically and horizontally.
NAPA CENTURY CENTER XD 12
#165582