specs

Section 09960
Page 6
Coat 1:
Coat 2:
Tnemec Series N69/V69 Epoxoline at 2.0-3.0 mils DFT
Tnemec Series 1075 Endura-Shield at 2.0-3.0 mils DFT
7. EXTERIOR GALVANIZED METAL
(Surface Preparation: SSPC-SP7 Brush-off Blast)
Coat 1: Tnemec Series N69/V69 Epoxoline at 2.5 – 3.0 mils DFT
Coat 2: Tnemec Series 1075 Endura-Shield at 2.5 – 3.0 mils DF
8. EXTERIOR ALUMINUM
(Surface Preparation: SSPC-SP1 and sanding with Scotch Bright pads)
Coat 1: Tnemec Series N69/V69 Epoxoline at 2.5 – 3.0 mils DFT
Coat 2: Tnemec Series 1929 Enduratone at 2.5 – 3.0 mils DF
9. INTERIOR CONCRETE AND CMU Walls (not receiving Series 158)
(Surface Prep. Per ASTM D 4258 & 4259; Series 130 only used for CMU)
Coat 1: Tnemec Series 130 Envirofill at 100 sq. ft. per gallon
Coat 2: Tnemec Series 113/114 Tufcoat at 3.0 to 5.0 mils DFT
Coat 3: Tnemec Series 113/114 Tufcoat at 3.0 to 5.0 mils DFT
10. New INTERIOR CONCRETE FLOORS (Moderate Traffic, Clear Finish)
(Surface Preparation: ASTM D 4260 & SSPC-SP13.)
Coat 1: Tnemec Series 203 Epoxoprime LV at 3.0 to 5.0 mils DFT
Coat 2: Tnemec Series 296 Enviro-Tread UR at 2.0 to 3.0 mils DFT
11. INTERIOR Ferrous and non Ferrous METAL-Previously Painted
(Surface Preparation: SSPC-SP2 orSP3)
Coat 1: Tnemec Series 135 Chembuild at 3.0 to 5.0 mils DFT
Coat 2: Tnemec Series 1028 Enduratone at 2.0 to 3.0 mils DFT
Coat 3: Same as Coat 2 if required for proper hiding
12. ANTI-MICROBIAL COATING SYSTEM (ceiling & upper walls)
(Surface Preparation per primer product data sheet)
Coat 1 for Wood and Concrete: Tnemec Series 151 Elasto-Grip at 200 to
350 sq. ft./gal.
Coat 1 for Metal: Tnemec Series 135 at 3.0 to 5.0 mils DFT
Coat 2: Tnemec Series 158 Bio-Lastic at 6-7 mils DFT.
Coat 3: Tnemec Series 158 Bio-Lastic at 6-7 mils DFT.
END OF SECTION
NAPA CENTURY CENTER XD 12
#165582