specs

Section 09960
Page 5
H. Transparent (Clear) Finishes: Use multiple coats to produce glass smooth surface film of even luster.
Provide a finish free of laps, cloudiness, color irregularity, runs, brush marks, orange peel, nail holes or other
surface imperfections.
I. Refinishing Wood Surfaces: Sand all existing clear finish wood surfaces. Fill all holes with stainable
wood putty. Stain all blemishes to match existing color. Apply two (2) coats satin urethane finish.
J. Refinishing Plaster and GWB Surfaces: Clean all surfaces per ASTM D 4258. Fill all holes and
blemishes; sand, prime and paint per new finishes.
3.05 CLEAN-UP AND PROTECTION
A. Clean-Up: During progress of work, remove from site discarded paint materials, rubbish, cans and rags
at end of each work day.
1. Upon completion of painting work, clean window glass and other paint
spattered surfaces. Remove spattered paint by proper methods of washing
and scraping, using care not to scratch or otherwise damage finished
surfaces.
B. Protection: Protect work of other trades, whether to be painted or not, against damage by painting and
finishing work. Correct any damage by cleaning, repairing or replacing, and repainting as acceptable to
Architect.
1. Provide “Wet Paint” signs as required to protect newly painted finishes.
Remove temporary protective wrappings provided by others for protection
of their work after completion of painting operations.
2. At the completion of work of other trades, touch-up and restore all damaged
or defaced painted surfaces.
3.06 FINISH PAINTING SCHEDULE
A. The following finish systems refer to products of Tnemec Company, Inc., unless indicated otherwise.
NAPA CENTURY CENTER XD 12
#165582
1. EXTERIOR MASONRY, PREVIOUSLY UNCOATED-Block, Brick, Precast, Cast in Place,
Concrete (Water repellency, graffiti protection)
Coat 1: Tnemec/Chemprobe Series V626 Dur A Pell GS at 75 to 150 sq ft. per gal.
Coat 2: Same as Coat 1
2. New EXTERIOR MASONRY PRECAST AND CONCRETE-Block, Brick, Cast in Place
Concrete
Coat 1: Tnemec Series 156 Enviro-Crete at 8-10 mils DFT (Dry Film Thickness)
Coat 2: Same as Coat 1
3. EXTERIOR PLASTER,GLAZED BRICK,AND PREVIOUSLY PAINTED
MASONRY
Coat 1: Tnemec Series 151 Elasto-grip 3.04 - 4.0 mils DFT
Coat 2: Tnemec Series 180 W. B. Tneme Crete at 5.0 to 7.0 mils DFT
4. Existing Exterior Ferrous Metal
Coat 1: Tnemec135 Chembuild at 3.0 to 5.0 mils DFT
Coat 2: Tnemec 1028 Enduratone at 2.0 to 3.0 mils DFT
5. New EXTERIOR FERROUS METAL
(Surface Preparation: SSPC-SP#6) Coordinate w/sections 05120, 05500
Coat 1: Tnemec Series 90-97 Tneme-Zinc (shop applied) at 3.0 mils DFT
Coat 2: Tnemec Series N69/V69 Epoxoline at 3.0 mils DFT
Coat 3: Tnemec Series 1080 Endura-Shield at 2.0 to 3.0 mils DFT
6. EXTERIOR NON-FERROUS METAL
(Surface Preparation: SSPC-SP#1) Followed by SSPC-SP3 or SP7