specs

Section 09950
Page 3
6. Ribs run vertically (parallel to selvage) in auditoriums and vestibules. Joints run horizontally at corridors,
lobbies and mezzanine stair. Joints run parallel to floor on ramps, following the slope and mitering at
angles at top and bottom. Carpet edges are to be covered with tile or corner guards.
B. Installation Procedure
1. Trim edges so as to balance seam between ribs (a very sharp edge must be maintained)
2. Position the striped selvage on left-hand side when cutting and installing.
3. Trim fabric on flat table prior to installing on the wall.
4. Apply heavy-duty pre-mixed vinyl adhesive to fabric with a notched trowel.
5. Install fabric from top to bottom, between two plumb lines for absolute vertical alignment.
6. Fabric should then be firmly pressed to wall using 1/4" nap roller to insure maximum contact between
adhesive and wall.
C. Adhesives
1. Adhesives to be used should be of the heavy duty vinyl type, with low water content, which dry clear or
translucent. If clay base is used cleanliness and workmanship must be maintained.
3.04 COORDINATION OF DRAPERY
A. Preparation:
1. Install blocking at bottom of fabric and around openings as required by Drawings.
2. Install all acoustical insulation prior to initiating sound fold work.
B. Installation of soundfold drapery will be by Cinemark USA.
C. Wood trim shall be furnished and installed by the contractor.
3.05 CLEAN-UP
A. Clean wall coverings of adhesives, dust, dirt, and other contaminants.
B. Remove excess materials and debris from the premises.
C. Replace wall plates and accessories.
3.06 EXTRA STOCK
A. Provide in accordance with Section 01750 - Spare Parts and Maintenance Materials.
B. Provide ten percent (10%) additional wall covering material, of each type, identical to that installed for
maintenance and replacement uses.
END OF SECTION
NAPA CENTURY CENTER XD 12
#165582