specs

Section 09800
Page 2
A. Protect adjacent surfaces from damage or overspray resulting from work of this trade. If necessary, mask
and/or cover adjacent surfaces, masonry, walls, equipment, etc. by suitable means. Make good such damage at
own expense, to Architect's satisfaction.
PART 2 - PRODUCTS
2.01 MANUFACTURER
A. Sherwin-Williams or equal
2.02 MATERIALS
A. Cementitious Blockfiller & Topcoat: For use on concrete masonry units; for exterior applications, and
both sides of auditorium demising CMU wall.
1. Sherwin-Williams: Cement Plex 875, B42W200/B42V200 (as required to fill voids and provide a
continuous substrate)
2. Surface must be clean, dry, sound, and offer sufficient profile to achieve adequate adhesion.
3. Minimum substrate cure is 28 days at 75 degress F.
4. Remove all form release agents, curing compounds, salts, efflorescence, laitance, and other foreign
matter by sandblasting, shotblasting, mechanical scarification, or suitable chemical means. Rinse
thoroughly with water to achive a final pH between 6.0 and 10.0.
5. 2 Finish Coats: Sherwin-Williams Loxon Acrylic Coating, A24W300 Series.
B. Decorative Acrylic Coating:
100% acrylic aggregate-filled coating used to produce a textured finish on properly prepared interior or
exterior sufaces. May be used on concrete, aggregate block, sheetrock, cement, primed steel, and primed
wood.
1. Sherwin-Williams Primers for decorative acrylic coating: For tilt wall applications use Loxon Concrete
Masonry Primer, A24W8300. For steel applications use Pro-Cryl Universal Metal Primer, B66-310
series, Foor Wood or Composition Board use Exterior Oil-Based Wood Primer, Y24W8020. For Drywall
Interior use ProMar 200 Int Latex Primer, B28W8200. For Drywall Exterior use Exterior Latex Wood
Primer, B42W8041.
2. Sherwin-Williams Topcoat: UltraCrete Texterure Coating Fine A44W801.
Apply two coats 50-80 sq ft/gal per coat depending on substrate porosity and texture size.
NAPA CENTURY CENTER XD 12
#165582
Performance Characteristics:
Wind-Driven Rain Test ASTM D6904-03 Passes
Water Vapor Permeance ASTM D1653 17.0 Perms
Flexibility ASTM D522-Method B Passes
Alkali Resistance ASTM D1308 Passes
Mildew Resistance ASTM D3273/3274 Passes
Impact Resistance ASTM D2794 Passes
Salt Spray ASTM B117, 300 hours No Damage
Adhersion ASTM D3359 Method B Passes
Freeze/Thaw Reistance ASTM D2243 Passes
C. Elastomeric Paint: Sherwin-Williams, two coat system, elastomeric paint meeting the following performance
requirements, in colors described on the Drawings. Provide finish coating over EIFS &/or Stucco building
surfaces ONLY WHEN EIFS &/or STUCO IS NOT AN INTEGRAL COLOR. A minimum total dry film
thickness of 13-15 mils per coat (excluding texture elastomeric coating) and a surface with 10 or less pinholes
per square foot is required for a waterproofing system.
1. Primer: for EIFS &/or Stucco application use Loxon Concrete & Masonry Primer, A24W8300 by
Sherwin- Williams.