specs

PART 1 - GENERAL
1.01 SCOPE
A. Provide Special Coatings work at locations listed and as described in the Contract Documents.
1. Exposed exterior concrete wall panels.
2. Stucco.
B. Work, items and requirements specified elsewhere that apply and/or relate to this Section include:
1. Concrete Wall Panels – Section 03411
2. Concrete Masonry Units – Section 04200
3. Sheet Metal Flashing and Trim – Section 07620
4. Portland Cement Plaster/Stucco – Section 09220
5. Gypsum Wallboard - Section 09250
6. Painting - Section 09900
SECTION 09800
SPECIAL COATINGS
1.02 QUALIFICATIONS
A. Materials shall be applied by skilled craftsmen trained to do this type work and employed by an approved
applicator approved by the manufacturer of the materials.
B. Applicator shall present proof of having had previous experience in doing this type of work.
1.03 SUBMITTALS
A. Refer to Section 01340 - Submittals.
B. Submit samples of coating applied to a 6"x 6" substrate sample. Include on backside: project name, material
identification, color, and provision for Architect's approval.
C. Before commencing work, supply samples selected by Architect of adequate size, of each coating type for
Architect's approval.
D. Provide product data or MSDS indicating VOC emissions in grams/liter (g/L) for the following products:
1. Comply with California’s South Coast Air Quality Management District (SCAQMD) #1113 identified in
Section 01352.
1.04 PRODUCT HANDLING
A. Deliver and store materials undamaged, in original containers, with manufacturer's labels and seals intact.
B. A room will be designated for storage of coating materials and equipment. Keep room neat and clean, and
surrounding surfaces protected against damage.
C. Material temperature shall be minimum of 35 degrees F to 100 degrees F.
1.05 GUARANTEE
A. Upon completion and acceptance of the project, the special coatings subcontractor and the General Contractor
shall furnish a joint written guarantee on the special coatings.
B. Provide limited warranty for materials and work included in this section for a period of five years from the date
of acceptance, against the following:
1. Bond and weathering.
2. Waterproofing above grade
C. Defects resulting from faulty materials and/or workmanship that are found during the guarantee period shall be
replaced by the subcontractor at his expense.
1.06 ENVIRONMENTAL CONDITIONS
A. Minimum surface temperature of 50º F 24 hours before, during and 24 hours after application until cured.
B. No precipitation for 24 hours preceding or predicted for 24 hours after application.
C. The following conditions may require dampening the surface prior to and during application:
1. Wind-caused rapid drying of surface.
2. Excessive surface temperature.
3. Excessive air temperature.
4. Direct sun.
5. Low humidity.
1.07 PROTECTION
NAPA CENTURY CENTER XD 12
#165582