specs

B. Perform glazing on dry surfaces only.
NAPA CENTURY CENTER XD 12
#165582
Section 08810
Page 2
1.06 GUARANTEE
A. Guarantee against defects in material and workmanship for two (2) years from date of Substantial Completion.
B. It is the intent of this Specification that exterior glazing shall be guaranteed to be weathertight.
PART 2 - PRODUCTS
2.01 MATERIALS
A. Glass:
1. Storefront and Entrance Doors: Solar Control Low-E Tinted Insulating Glass. “Solarban 60 (2)”
“Solargray + Clear by PPG Industries, Inc.
Outdoor Lite: “Solargray” Glass by PPG Industries, Inc., Sputter Coated on second surface (2)
Indoor Lite: Clear Float Glass
Low-E Coating: “Solargray” 60 Solar Control (Sputtered) by PPG Industries, Inc.
Location: Second Surface (2)
Performance Values: Visible Light Transmission U-Value Winter U-Value Summer SHGC Shading
Coefficient Outdoor Visible Light Reflectance
35% 0.29 0.27 0.24 0.28 6%
2. Mirrors: 1/4" thick clear float glass, size 24”x36”, with mill finish aluminum j-mold, at all edges.
Provide as shown in all restrooms, quanity shown on drawings.
3. Door Viewports: 1/4" nominal thickness tempered glass equal to that manufactured by PPG’s float glass.
4. Decorative Glass: Spandral Panels, refer to drawings for layout. White Spandrel PPG Starphire Ultra-
Clear with White Frit, ½” thick tempered glass. Apply ICD High Performance Coating Opaci-Coat 3000-
0186 Light White silicone film to inside face of glazing. Glazing sample to be approved by architect.
5. Curtainwall: Solar Control Low-E Tinted Insulating Glass. “Solarban 60 (2)” “Solargray + Clear by
PPG Industries, Inc.
Low-E Coating: “Solargray” 60 Solar Control (Sputtered) by PPG Industries, Inc.
Location: Second Surface (2)
Performance Values: Visible Light Transmission U-Value Winter U-Value Summer SHGC Shading
Coefficient Outdoor Visible Light Reflectance
35% 0.29 0.27 0.24 0.28 6%
Glazing sample to be approved by architect.
B. Environmental Information
1. Provide material with maximum amount of recycled content available that achieves performance
requirements of this Section,
2. Provide material with maximum amount of regional (within 500 miles) material feasible that achieves
performance requirements of this Section.
C. Glass Accessories:
1. General:
a. Setting Blocks-Neoprene, 70-90 Shore "A" durometer hardness.
b. Spacers-Neoprene, 40-50 Shore "A" durometer hardness.
c. Glazing Points and Wire Spring Clips-Corrosion resistant, manufacturer's standard.
d. Mirror Edge Sealant: PPG's Mirror Edge Sealant UC44554.
e. Primer-Sealant-equal to GE's 1200 Silicone Sealant or Dow 781 clear, 25% max, movement.
f. Mirror mastic: Mirror-Mastic by Palmer Products Corporation.
g. Glass Clips and Fasteners: Knape and Vogt Nos. 277 and 278.
PART 3 - EXECUTION
3.01 INSPECTION
A. Check that glazing channels are free of burrs, irregularities and debris.
B. Check that glass is free of edge damage or face imperfections.
C. Do not proceed with installation until conditions are satisfactory.
D. Verify that glass is installed in accordance with original design, and in accordance with pertinent codes and
regulations.
3.02 PREPARATION