specs

PART 1 - GENERAL
1.01 SCOPE
A. Provide Finish Hardware work as indicated by the Contract Documents.
B. Work, items and requirements specified elsewhere that apply and/or relate to this Section include:
1. Metal Doors & Frames - Section 08100
2. Plastic Faced Wood Doors - Section 08212
3. Aluminum Entrances & Storefront - Section 08410
1.02 STANDARDS
A. Meet requirements and recommendations of applicable portions of the Standards listed.
1. Builder's Hardware Manufacturer's Association BHMA
2. Underwriter's Laboratories, Inc. UL
3. National Board of Fire Underwriters NBFU
4. National Fire Protection Association NFPA
SECTION 08710
FINISH HARDWARE
1.03 SUBMITTALS
A. Refer to Section 01340 - Submittals.
B. Submit electronic hardware schedules with all information necessary to completely describe hardware for review
and comments by the Architect.
NO ALTERNATES WILL BE ACCEPTED FOR FINISH HARDWARE.
C. Templates and schedules shall be furnished to manufacturers of items that will be fitted with finish hardware in
ample time to avoid delays in the work.
D. With the hardware submittal, identify the name and phone number of the local Best Lock Corporation Supplier.
E. Recycled Content:
1. Indicate recycled content; indicate percentage of pre-consumer and post-consumer recycled content per unit of
product.
2. Indicate material cost of product less labor included in project.
3. If recycled content product is part of an assembly, indicate the percentage of recycled content product in the
assembly by weight.
F. Local/Regional Materials:
1. Sourcing location(s): Indicate location of extraction, harvesting, and recovery; indicate distance between
extraction, harvesting, and recovery and the project site.
2. Manufacturing location(s): Indicate location of manufacturing facility; indicate distance between
manufacturing facility and the project site.
3. Product Value: Indicate dollar value of product containing local/regional materials; include materials cost
only.
4. Product Component(s) Value: Where product components are sourced or manufactured in separate locations,
provide location information for each component. Indicate the percentage by weight of each component per
unit of product.
1.04 DELIVERY AND STORAGE
A. Schedule deliveries to avoid delays in the work.
B. Store hardware items to prevent damage.
PART 2 - PRODUCTS
2.01 MATERIALS: Refer to schedule for location
A. Suspension
1. 3BB: 1 1/2 pairs Bommer BB5006 4½x4½, full mortise, coated black at auditorium entrance, exit and
screen doors. Finish shall be stainless steel at all other doors.
2. 3BB-N: same as Bommer BB5006, with non-removable pin, coated black at auditorium entrance doors.
Finish shall be stainless steel at all other doors.
3. 4BB: 3 pairs Bommer BB5006 4½x4½, full mortise, coated black at auditorium entrance, exits & screen
doors. Finish shall be stainless steel at all other doors.
4. CH: Half Surface Contious Hinge, Stanley 663HD, Aluminum clear coated finish, (for fire doors).
B. Function/Trim
NAPA CENTURY CENTER XD 12
#165582