specs

4. The system shall provide fully resilient settings for glass and panels by use of E.P.D.M. elastomeric
gaskets on both sides of the glass.
7. Provide the necessary miscellaneous steel reinforcing and anchors to adequately secure the storefront to
withstand wind loads as required by local building code.
8. One piece tube construction shall be used to frame entrances.
9. Provide material with maximum amount of recycled content available that achieves performance
requirements of this Section,
10. Provide material with maximum amount of regional (within 500 miles) material feasible that achieves
performance requirements of this Section,
C. Aluminum Glazing Channels:
1. Glazing channels shall be equivalent to Blumcraft's C-7500 Ceiling Glazing Channel for 1/2" glass on top
and sides; no channel at base. Medium bronze anodized finish.
2. Provide complete with necessary gaskets, setting blocks, fasteners and reinforcing.
D. Aluminum Finish for Storefront and Channels:
1. Material shall be free of scratches and other serious blemishes and chemically cleaned.
2. Exposed Aluminum surfaces shall be finished medium bronze anodized.
3. The minimum coating thickness shall be 0.70 mil when measured per ASTM B244-79, and the density
shall be at least 32 mg. per square inch when measured per ASTM B137-95.
E. Hardware: Refer to schedule of location
1. Suspension:
a. P1: Pivots/Offset, per manufacture: Kawneer Top/Bottom & Intermediate Standard; U.S. Aluminum
OP400 for Top/Bottom, & DH010 for Intermediate; Vistawall OP-6/OP-7 for Top/Bottom, & OP-11
for Intermediate. Finish to match storefront.
2. Function/Trim:
a. PA: Passage: Best Cylindrical Lockset #93K-0-N-15N-S3-694; lever always operable, L3/694
Medium Bronze. (Party Room Storefront Door located on the public side)
b. PULLS: Storefront Door Pull Bars: Bollen Resources Series 48RL doorpulls, black satin finish.
Provided by Cinemark and installed by GC.
c. ED1: Exit Device with dogging, per manufacture: Kawneer Mid-Panel Exit Device; U.S. Aluminum
Mid-Panel Exit Device; Oldcastle VIP1390, with NO key access.
d. ED2: Exit Device – Mid-Panel Exit Device with dummy push panel, per manufacture.
e. ED3: Exit Device with dogging, per manufacture: Kawneer Mid-Panel Exit Device; U.S. Aluminum
Mid-Panel Exit Device; Oldcastle VIP1390, with keyed Best cylinder. Key to retract latch bolt on
one door,finish to match storefront. Provide Best cylinder for one of the double doors.
3. Closer:
a. E: LCN 4041-DEL-EDA: surface mount with extra duty parallel arm and delayed action; finish to
match storefront for all doors. Mount closer on either PUSH or PULL side of door as noted in the
hardware schedule.
b. HCO1: Handicap Automatic Door Opener Button. Manufactured by Curran Engineering model#CE-
635-FM, 4 ½” or Equal. No Wireless. Leaf to receive automatice door opener, opener to be record
USA 8100 series. Refer to drawings for location and if exterior push button is to be wall or pole
mounted.
4. Stop:
a. FS: Floor stop: Rockwood #481 with 1-3/8" stop height, Satin Chrome US26D/652 finish, furnish
with 1 1/2” expansion anchors.
5. Weatherstripping, etc:
a. TH: Threshold equivalent to Reese 4” #S239A, bed in sealant, Typ.
6. Keying:
a. Reference Section 08710.
NAPA CENTURY CENTER XD 12
#165582