specs

A. Schedule deliveries to avoid delay in the work.
B. Deliver and store materials in their original unopened containers bearing the manufacture's label.
C. Protect materials.
D. Store materials to allow easy access to the work.
1.05 GUARANTEE
A. Upon completion and acceptance of the project, furnish to the Owner through the Architect a written guarantee.
B. Guarantee items and work included in the Section for a period of two years from the date of acceptance against
defects in materials and/or workmanship.
C. Defects resulting from faulty materials and/or workmanship during the guarantee periods shall be repaired or
replaced by the Contractor at his expense.
PART 2 - PRODUCTS
2.01 ACCEPTABLE MANUFACTURERS
A. Products of the following manufacturers are considered to be of the quality required.
1. U.S. Aluminum
2. Oldcastle
3. Kawneer
B. Product substitutions shall be in accordance with Section 01600.
2.02 MATERIALS
A. Entrances
Firm Type Stile Top Rail Bottom Rail
U.S. Aluminum Wide Style 550 5” 5 ½” 10”
Oldcastle Wide Stile 500 5 ½” 4 ½” 10”
Kawneer Wide Stile 500 5” 5” 10”
1. Corner construction shall consist of both sigma deep penetration weld and mechanical fastening.
2. Glazing stops shall be snap-in type with neoprene bulbtype glazing. No exposed screws shall be required
to secure stops. Stops on exterior side shall be lock-in tamper proof type.
3. Door leaf shall be equipped with adjustable mechanism located in top rail near lock stile which will
provide for minor clearance adjustments after installation.
4. Provide with nylon pad setting blocks for glazing bead with offset "Levelizer" to allow adjustment of
glazing.
5. Provide material with maximum amount of recycled content available that achieves performance
requirements of this Section,
6. Provide material with maximum amount of regional (within 500 miles) material feasible that achieves
performance requirements of this Section,
B. Storefront - (If noted on drawings.)
Firm Type Size
U. S. Aluminum 450 Center Glaze System 1 ¾” x 4 ½” for Party Room
Oldcastle Series 2000 1 ¾” x 4 ½” for Party Room
U.S. Aluminum 451 Center Glaze 2” x 4 ½”
Oldcastle Series 3000 2” x 4 ½”
1 Framing members, transition member, mullions, adapters and mountings shall be extruded of aluminum
with alloy and temper consistent with the method of manufacture. These members shall be of 6063-T5
extruded aluminum alloy (ASTM B221/B221m-95a, alloy G.S. 10A-T5).
2. Screws, miscellaneous fastening devices and internal components shall be of stainless steel, or plated with
corrosion-resistant materials of sufficient strength to perform the functions for which they are used.
3. Glass framing members shall provide for flush glazing on sides with through sight lines, and no projecting
stops or face joints.
NAPA CENTURY CENTER XD 12
#165582