specs

Section 08212
Page 3
C. Accessories:
1. Louvers: Sizes as scheduled on mechanical drawings, inverted "V" type, 50% free area; door shall be
factory prepared for louver. Paint as directed by Architect.
2. Glass openings: Size 4”x60”, Anemostat FGS-75 vision frame. Provide with black satin finish. Factory
prepared for glazing installation.
3. Glass: sizes and location as scheduled with 1/4" nom. thick tempered glass.
4. Edge Trim: Similar to DON-JO U-Channel 1298, stainless steel finish, height to be 84”, with “A” depth of
1”. U-channels are to be fully adhered with adhesive & to be flush with the laminate. NOT to be installed
on top of the laminate or with screws.
C. VOC emissions: Provide low VOC products.
1. Adhesives and sealants: Comply with California’s South Coast Air Quality Management District
(SCAQMD) #1168 identified in Section 01352.
2. Aerosol adhesives: Comply with Green Seal GS-36 identified in Section 01352
3. Clear wood finishes: Comply with SCAQMD #1113 identified in Section 01352
PART 3 - EXECUTION
3.01 WORKMANSHIP AND INSTALLATION
A. Install in accordance with requirements of manufacturer's instructions.
B. Doors shall be drilled and fitted to leave equal width stiles on each side and equal headrail and fit snugly
without binding. Allowance shall be made when fitted so doors will close without forcing and to prevent any
rattling with hardware cuts true and neat. Immediately after hanging doors, remove them and coat top and
bottom edges with materials specified in Painting Section.
C. Bevel lock edges of single acting doors 1/8" in 2".
D. Allow 1/8" at jambs and head.
E. Over threshold, allow 3/16" clearance above finished floor material.
F. For openings without threshold, allow 3/8" above finished floor material.
G. Doors shown on Drawings but not specifically mentioned herein above, but which are required to make
complete installation, shall be furnished under this Section. The grade and type of door shall be in keeping with
the surrounding or adjacent materials as required to make a consistent job. The General Contractor shall verify
finishes prior to ordering materials.
3.02 ADJUST AND CLEAN
A. Refer to Section 01710 - Cleaning.
B. Rehand and replace doors which do not swing or operate freely, as directed by the Architect.
C. Refinish or replace doors damaged prior to acceptance of the work.
END OF SECTION
NAPA CENTURY CENTER XD 12
#165582