specs

PART 1 - GENERAL
NAPA CENTURY CENTER XD 12
#165582
SECTION 08212
PLASTIC FACED WOOD DOORS
1.01 SCOPE
A. Provide Wood Door work as indicated by the Contract Documents.
B. Work, items and requirements specified elsewhere that apply and/or relate to this Section include:
1. Rough Carpentry - Section 06100
2. Metal Doors and Frames - Section 08100
3. Finish Hardware - Section 08710
4. Glass and Glazing - Section 08810
1.02 STANDARDS
A. Meet requirements and recommendations of applicable portions of the Standards listed.
1. American Plywood Association APA, DFPA
2. Architectural Woodwork Institute AWI
3. National Forest Products Association NFPA
4. National Woodwork Manufacturers Assoc. NWPA
1.03 QUALITY ASSURANCE
A. Acceptable Manufacturers: Qualified to affix each door with National Woodwork Manufacturer's Assoc.
(NWMA) Quality Certification Stamp.
B. Identify as to construction and manufacturer with a stamp, dowel, label, or other readily recognized, permanent
mark on door.
C. Testing Requirements:
1. Bonding NWMA I.S. 1-78
D. Allowable Tolerances:
1. Size + 1/16".
2. Maximum Warp or Twist: 1/4"
3. Squareness:
a. Square corners
b. Maximum difference in diagonals measured on the face of door from upper right corner to lower left
corner and upper left corner to lower right corner: 1/8".
1.04 SUBMITTALS
A. Refer and comply with Section 01340 - Submittals.
B. Certificates: Certificate of compliance with fabrication and test requirements of NWMA I.S. 1-78.
C. Manufacturers Instructions: Furnish installation and hanging instructions for doors, including fire rated doors
where scheduled.
D. Submit (4) samples of each Plastic Laminate color and finish required for Wood Doors.
E. Certification for Sustainable Forestry:
1. Forest Stewardship Council (FSC): Provide letter of certification signed by lumber supplier. Indicate
compliance with FSC "Principles for Natural Forest Management" and identify certifying organization.
a. Submit FSC certification numbers; identify each certified product on a line-item basis.
F. Submit copies of invoices for all wood materials identifying material cost not including labor. Invoices for
FSC certified products shall identify FSC chain of custody (COC) number.
G. E. VOC emissions: Provide low VOC products.
1. Adhesives and sealants: Comply with California’s South Coast Air Quality Management District
(SCAQMD) #1168 identified in Section 01352.
2. Aerosol adhesives: Comply with Green Seal GS-36 identified in Section 01352
3. Clear wood finishes: Comply with SCAQMD #1113 identified in Section 01352
4. Engineered Wood Products: Provide products with no added urea formaldehyde.
Note: The submittals for the Wood Doors will not be reviewed until all required Plastic Laminates have
been received.
1.05 PRODUCT DELIVERY, HANDLING AND STORAGE
A. Deliver material to project site in manufacturer's original unopened protective wrapper.