specs

Section 08100
Page 3
6. Hardware furnished by the hardware contractor for single- acting doors shall be designed for beveled
edges as specified in sub-paragraph 5 above.
7. Hardware reinforcements:
a. Doors shall be mortised, reinforced, drilled, and tapped at the factory for fully templated hardware
only, in accord with the approved hardware schedule and templates provided by the hardware
contractor. Where surface-mounted hardware is to be applied, doors shall have reinforcing plates;
drilling and tapping shall be done in the field.
b. Minimum gauges for hardware reinforcing plates shall be as follows: Hinge and pivot
reinforcements - 9 gauge. Reinforcements for lock face, flush bolts, concealed holders, concealed or
surface mounted closures - 12 gauge. Reinforcements for other surface-mounted hardware - 15
gauge.
8. Reinforce and frame openings required for glazing and louvers. Provide glazing stops with countersunk
flat head screws. Place removable stops for glazing and louvers on "inner" or room side of doors.
9. Design doors for 1/8" clearance at sills, unless greater undercut indicated, 1/8" at head and lock jamb.
Contractor to coordinate undercut with specified thresholds where applicable.
3.02 SHOP FINISH
A. Clean inaccessible surfaces of ferrous metals and coat with rust-inhibitive paint.
B. Surfaces of doors shall be thoroughly cleaned and exposed surfaces shall be filed and ground smooth. Surfaces
shall be given as phosphate treatment conforming to Fed. Spec. TT-C-490 and then be given one coat of
baked-on rust-inhibitive primer.
C. Non-ferrous metals shall not be given prime coat.
3.03 CLEAN-UP AND PROTECTION
A. Refer to Section 01710 - Cleaning. Clean doors and frames from soil and stain that would interfere with finish
painting.
B. Protect doors and frames from damage after they have been installed.
END OF SECTION
NAPA CENTURY CENTER XD 12
#165582