specs

A
PART 1 - GENERAL
SECTION 07920
SEALANTS AND CAULKING
1.01 SCOPE
A. Provide Sealant and Caulking work as indicated by the Contract Documents.
B. Work, items and requirements specified elsewhere that apply and/or relate to this Section include:
1. Cast-in-Place Concrete - Section 03300
2. Concrete Wall Panels - Section 03411.
3. Exterior Insulation and Finish System – Section 07240.
4. Sheet Metal Siding, Flashing and Trim - Section 07620
5. Aluminum Entrances and Storefront - Section 08410
6. Gypsum Wallboard - Section 09250
7. Painting - Section 09900
C. The storefront installer is responsible for all interior and perimeter joint sealant installation.
D. Interior latex caulking shall be performed by painting subcontractor.
1.02 STANDARDS AND QUALITY
A. Meet requirements and recommendations of applicable portions of standards listed.
1. American Society for Testing and Materials ASTM
2. Federal Specifications FedSpec
1.03 SUBMITTALS
A. Before ordering material, submit for the Architect's approval complete manufacturer's specifications of
materials specified in this Section in accordance with Section 01340 - Submittals.
B. Product data sheet or MSDS indicating VOC emissions in grams/Liter (g/L).
1.04 DELIVERY AND STORAGE
A. Deliver and store materials in their original unopened containers bearing the manufacturer's label.
B. Deliver, store, and handle all materials so as to prevent the entrance of foreign materials and damage of
materials by water or breakage.
C. Store materials to allow free access to the work.
D. Schedule deliveries to avoid delay in the work.
E. Protect materials from damage during storage.
1.05 GUARANTEE
A. Upon completion and acceptance of the project, furnish to the Owner through the Architect a written
guarantee.
B. Guarantee items and work included in this Section for a period of two years from the date of acceptance
against defective workmanship and/or materials.
C. Defects resulting from faulty materials and/or workmanship during the guarantee period shall be
repaired or replaced by the Contractor at his expense.
D. This guarantee shall be issued by the General Contractor and the applicator for the full two years.
PART 2 - PRODUCTS
2.01 ACCEPTABLE MANUFACTURERS
A. Dow Corning
B. Pecora Corp.
C. Sika
D. Sonneborn Building Product, Inc.
E. Tremco Manufacturing Co.
F. Sherwin Williams Co.
NAPA CENTURY CENTER XD 12
#165582