specs

Section 07610
Page 1
SECTION 07610
METAL ROOF PANELS
PART 1 GENERAL
1.1 RELATED DOCUMENTS
A. Drawings and general provisions of Contract, including General and Supplementary Conditions
and Division 1 Specification Sections, apply to this Section.
1.2 SUMMARY
A. This Section includes, but is not necessarily limited to:
1. Furnishing and installation of all preformed metal roofing and walls, and accessories as
indicated on the drawings and specified herein.
B. Related Sections:
C. The following sections contain requirements that relate to this Section:
1. Structural Steel: Section 05100
2. Metal Roof Deck: Section 05300
3. Miscellaneous Metals: Section 05500
1.3 SUBMITTALS
A. PRODUCT DATA
1. Submit Manufacturer’s technical product data, installation instructions and recommendations for
each type of roofing and wall panel required. Include data substantiating that materials comply
with requirements.
2. Recycled Content:
a. Indicate recycled content; indicate percentage of pre-consumer and post-consumer recycled
content per unit of product.
b. Indicate relative dollar value of recycled content product to total dollar value of product
included in project.
c. If recycled content product is part of an assembly, indicate the percentage of recycled content
product in the assembly by weight.
d. If recycled content product is part of an assembly, indicate relative dollar value of recycled
content product to total dollar value of assembly.
3. Local/Regional Materials:
a. Sourcing location(s): Indicate location of extraction, harvesting, and recovery; indicate
distance between extraction, harvesting, and recovery and the project site.
b. Manufacturing location(s): Indicate location of manufacturing facility; indicate distance
between manufacturing facility and the project site.
c. Product Value: Indicate dollar value of product containing local/regional materials; include
materials cost only.
d. Product Component(s) Value: Where product components are sourced or manufactured in
separate locations, provide location information for each component. Indicate the percentage
by weight of each component per unit of product.
B. SAMPLES
1. Prior to ordering products, submit Manufacturer’s standard color Samples for
Architect’s/Engineer’s selection.
2. Prior to starting work, submit two 12” long Panel Samples showing shape and a representative
color chip for Architect’s/Engineer’s acceptance.
C. SHOP DRAWINGS
NAPA CENTURY CENTER XD 12
#165582