specs

PART 1 - GENERAL
SECTION 07535
FULLY ADHERED SINGLE PLY MEMBRANE ROOFING
1.01 SCOPE
A. Provide Roofing Work to produce a weatherproof, watertight covering complying with FM I-90 requirements
for the locality as indicated by the Contract Documents.
B. Work, items and requirements specified elsewhere that apply and/or relate to this Section include:
1. Miscellaneous Metals - Section 05500
2. Rough Carpentry - Section 06100
3. Sheet Metal & Flashing - Section 07620
4. Sealants and Caulking - Section 07920
5. Mechanical - Division 15
6. Electrical - Division 16
1.02 STANDARDS AND QUALITY
A. Meet requirements and recommendations of the applicable portions of Standards listed.
1. National roofing Contractors Association NRCA
2. American Society for Testing and Materials ASTM
3. Underwriter's Laboratories UL
1.03 SUBMITTAL
A. Before material is ordered, submit for the Architect's approval complete specifications of the respective
manufacturer's materials and systems that are proposed to be used including recommended changes in method
of application. This should include insulation layout, fastening pattern and sample warranty that is project
specific.
B. There shall be no deviations made from this specification or the approved shop drawings without the prior
written approval of the specifier. Any deviation from the manufacturer's installation procedures must be
supported by written certification on manufacturer's letterhead and presented for the specifier's consideration.
C. If no changes in methods or materials are recommended within 30 days prior to application, it shall be
understood that the Contractor is in agreement with the terms of these Specifications, and he will guarantee the
work as specified herein.
D. Provide details per manufacture indicated matching roof details per architectural plans.
E. Provide example of warranty with submittal.
F. FM Global submittals shall be issued to the attention to the architect. Where then architect will
distribute to FM Global for review & approval.
1. Provide FM approved Roof Assembly Number from RoofNav (www.roofnav.com). If the number is not
known, submit the following information for FM review and a number will be provided;
2. Materials (Manufacturers, model and size of insulation boards, vapor barriers, adhesives, membranes and
any other components of the system.)
3. Roofing system specifications, if approved as a system.
4. Fastneing specifications, including the manufacturere’s name, model, and the proposed fastening density.
5. Drawings and details.
6. A complete Application for Acceptance of Roofing System FM Global Form 2688 will capsulate the roof
covering information.
G. All information is not provided then submittal will be marked as revise and resubmit.
1.04 QUALITY ASSURANCE
A. Applicator of the roofing and insulation shall be approved applicator by the manufacturer of the material.
B. Workmen trained and skilled in this type of work shall be used.
C. Schedule and execute work to prevent leaks and excessive traffic on completed roof sections. Care should be
exercised to provide protection for the interior of the building and to ensure water does not flow beneath or
wick into any completed sections of the membrane system.
D. Upon completion of the installation, the applicator shall arrange for an inspection to be made by a non-sales
technical representative of the membrane manufacturer in order to determine whether or not corrective work
NAPA CENTURY CENTER XD 12
#165582