specs

PART 1 - GENERAL
NAPA CENTURY CENTER XD 12
#165582
SECTION 06200
FINISH CARPENTRY
1.01 SCOPE
A. Provide Finish Carpentry as indicated by the Contract Documents.
B. Work, items and requirements specified elsewhere that apply and/or relate to this Section include:
1. Rough Carpentry - Section 06100
2. Metal Doors & Frames - Section 08100
3. Finish Hardware - Section 08710
4. Painting - Section 09900
1.02 STANDARDS
A. Meet requirements and recommendations of applicable portions of the Standards listed.
1. American Plywood Association APA, DFPA
2. Architectural Woodwork Institute AWI
3. American Wood Preservers Institute AWPI
4. National Forest Products Association NFPA
5. Southern Pine Inspection Bureau SPIB
1.03 MATERIAL GRADING
A. The grades of the material used shall be defined by the rules of the recognized associations of the lumber
manufacturers producing the material specified, but the maximum defects permissible in the specific grade
shall not exceed the limitations of the American Lumber Standards.
B. Defects expressly prohibited by this Section shall not appear in the material used, even if permissible in the
grade specification.
C. The sizes specified are nominal board measure dimensions unless otherwise noted.
1.04 SUBMITTALS
A. Meet requirements of Section 01340 - Submittals.
B. Recycled Content:
1. Indicate recycled content; indicate percentage of pre-consumer and post-consumer recycled content per
unit of product.
2. Indicate material cost of product less labor included in project.
3. If recycled content product is part of an assembly, indicate the percentage of recycled content product in
the assembly by weight.
C. Local/Regional Materials:
1. Sourcing location(s): Indicate location of extraction, harvesting, and recovery; indicate distance
between extraction, harvesting, and recovery and the project site.
2. Manufacturing location(s): Indicate location of manufacturing facility; indicate distance between
manufacturing facility and the project site.
3. Product Value: Indicate dollar value of product containing local/regional materials; include materials
cost only.
4. Product Component(s) Value: Where product components are sourced or manufactured in separate
locations, provide location information for each component. Indicate the percentage by weight of each
component per unit of product.
D. Certification for Sustainable Forestry:
1. Forest Stewardship Council (FSC): Provide letter of certification signed by lumber supplier. Indicate
compliance with FSC "Principles for Natural Forest Management" and identify certifying organization.
a. Submit FSC certification numbers; identify each certified product on a line-item basis.
E. Submit copies of invoices for all wood materials identifying material cost not including labor. Invoices for
FSC certified products shall identify FSC chain of custody (COC) number.
F. Provide product data or MSDS indicating VOC emissions in grams/liter (g/L) for the following products:
1. Adhesives and sealants: Comply with California’s South Coast Air Quality Management District
(SCAQMD) #1168 identified in Section 01352.
2. Aerosol adhesives: Comply with Green Seal GS-36 identified in Section 01352
3. Clear wood finishes: Comply with SCAQMD #1113 identified in Section 01352