specs

PART 1 - GENERAL
1.01 SCOPE
A. Provide Rough Carpentry work as indicated by the Contract Documents.
B. Work, items and requirements specified elsewhere that apply and/or relate to this Section include:
1. Miscellaneous Metals- Section 05500
2. Painting- Section 09950
3. Wallcoverings- Section 09950
1.02 STANDARDS
A. Meet requirements and recommendations of applicable portions of Standards listed.
1. Product Standards PS
2. American Plywood Association APA, DFPA
3. Architectural Woodwork Institute AWI
4. American Wood Preservers Institute APWI
5. American Society for Testing & Materials ASTM
6. National Forest Products Assoc. NFPA
7. Southern Pine Inspection Bureau SPIB
8. Federal Specifications FedSpec.
SECTION 06100
ROUGH CARPENTRY
1.03 QUALITY ASSURANCE
A. Comply with governing codes and regulations. Provide products of acceptable manufacturers which have been
in satisfactory use in similar service.
B. Lumber grading rules and species:
1. Western Wood Products Association (WWPA).
2. Southern Forest Products Association (SPFA).
C. Plywood Grading Rules and Recommendations:
1. American Plywood Association (APA).
D. Standards for fire hazard classification for fire retardant treated material.
1. Test method: ASTM E84-95b, NFPA 255, UL 723.
E. Preservative and pressure treatment standards: American Wood Preservers Association (AWPA).
F. VOC emissions: Provide low VOC products.
1. Adhesives and sealants: Comply with California’s South Coast Air Quality Management District
(SCAQMD) #1168 identified in Section 01352.
2. Aerosol adhesives: Comply with Green Seal GS-36 identified in Section 01352
3. Clear wood finishes: Comply with SCAQMD #1113 identified in Section 01352
4. Engineered Wood Products: Provide products with no added urea formaldehyde.
1.04 SUBMITTALS
C. Recycled Content:
5. Indicate recycled content; indicate percentage of pre-consumer and post-consumer recycled content per
unit of product.
6. Indicate material cost of product less labor included in project.
7. If recycled content product is part of an assembly, indicate the percentage of recycled content product in
the assembly by weight.
D. Local/Regional Materials:
1. Sourcing location(s): Indicate location of extraction, harvesting, and recovery; indicate distance between
extraction, harvesting, and recovery and the project site.
2. Manufacturing location(s): Indicate location of manufacturing facility; indicate distance between
manufacturing facility and the project site.
3. Product Value: Indicate dollar value of product containing local/regional materials; include materials cost
only.
NAPA CENTURY CENTER XD 12
#165582