specs

Section 05330
Page 4
1. Weld at least 2 shear studs at start of each work period to determine proper generator, control unit, and
stud welder settings. Bend studs 45 degrees from vertical by striking with hammer. Inspect weld. Do not
include these 2 studs in required total number of studs on Project.
2. Visually inspect welds at shear studs. Test studs which do not appear to have full sound 360 degree fillet
weld at base. Test by bending 15 degrees from vertical toward nearest end of beam by striking with
hammer. Replace studs which fail this test.
3. When temperature is below 32 degrees F, test one stud in each 100 studs after weld cools. If stud fails in
weld, test 2 additional studs. Do not resume welding unless 2 additional studs pass test.
3.05. ADJUSTING
A. Field Touch Up of Deck: After erection, use cold galvanizing compound to touch up both sides of deck at
welds, weld scars, bruises, and rust spots.
END OF SECTION
NAPA CENTURY CENTER XD 12
#165582