specs

Section 05330
Page 2
4. Product Component(s) Value: Where product components are sourced or manufactured in separate
locations, provide location information for each component. Indicate the percentage by weight of each
component per unit of product.
E. Submit information on EPA Waste Minimization Priority Chemicals associated with products provided under
work of this Section. For each Priority Chemical, indicate whether the Priority Chemical is produced as a byproduct
during manufacture and whether it is contained in the final product. Indicate amount produced during
manufacture and the amount contained in final product in terms of percentage by weight per unit of product.
1.04. QUALITY ASSURANCE
A. Welding:
1. Use welding procedures and techniques, welders, and tackers which are qualified in accordance with
AWS D1.1.
2. Maintain current AWS certification throughout duration of Project for welders employed on Work.
1.05. DELIVERY, STORAGE AND HANDLING
A. Deck:
1. Deliver, store, handle and install steel deck and accessories so as not to damage or deform.
2. Stack deck, stored at site before erection, on platforms or pallets and cover with tarpaulins or other
suitable covering to provide weathertight enclosure and to afford proper air circulation.
3. Do not use deck for storage or as a working platform until sheets have been securely fastened in position.
Do not damage or overload deck during construction period.
4. Do not use damaged deck. Replace damaged deck with new material at no additional cost to Owner.
5. Wirebrush and re-coat rusted areas on deck within 24 hours of detection.
B. Shear Studs:
1. Store in dry condition, above ground.
PART 2 - PRODUCTS
2.01. MATERIALS
A. Shear Studs:
1. Provide shear stud connectors with proper ferrules and accessories especially designed to create
composite deck action by mating of shear connectors, concrete deck and supporting beam, and capable of
providing shear forces shown on Drawings when welded through deck used on Project.
2. Comply with ASTM A108, Grades C1010-1020, with minimum tensile strength of 60,000 psi.
3. Diameter: uniform.
4. Head: concentric with and normal to shaft.
5. Weld Ends: chamfered and solid flux.
6. Height: at least 1-1/2 inches above top of deck after installation, with at least 1/2 inch clear concrete
cover above top of stud.
B. Cold Galvanizing Compound: ZRC, as manufactured by ZRC Chemical Products Co., Quincy, Mass.
2.02. ENVIRONMENTALLY PREFERABLE PRODUCTS
A. To the greatest extent possible, provide products and materials that promote stewardship of the earth's
resources, promote good indoor environmental quality (IEQ), and promote efficiencies in operational
performance.
B. Provide products listed on the EPA Comprehensive Procurement Guidelines to the greatest extent practicable.
C. Provide products listed on the USGBC Directory of Products and Services to the greatest extent possible.
2.03. RECYCLED CONTENT
A. Provide material with maximum amount of recycled content available that achieves performance requirements
of this Section.
2.04. REGIONAL MATERIALS
A. Provide material with maximum amount of regional (within 500 miles) material feasible that achieves
performance requirements of this Section.
2.05. MANUFACTURED UNITS
NAPA CENTURY CENTER XD 12
#165582