specs

Section 05320
Page 2
resources, promote good indoor environmental quality (IEQ), and promote efficiencies in operational
performance.
B. Provide products listed on the EPA Comprehensive Procurement Guidelines to the greatest extent practicable.
C. Provide products listed on the USGBC Directory of Products and Services to the greatest extent possible.
2.03. RECYCLED CONTENT
A. Provide material with maximum amount of recycled content available that achieves performance requirements
of this Section.
2.04. REGIONAL MATERIALS
A. Provide material with maximum amount of regional (within 500 miles) material feasible that achieves
performance requirements of this Section.
PART 3 - EXECUTION
1.01. ERECTION OF METAL FLOOR DECK
A. Place metal floor deck with corrugation edges up and with corrugations perpendicular to supports and
continuous over 3 spans.
B. Lap ends 2 inches minimum.
C. Weld sheets to supports with 5/8 inch diameter puddle welds:
1. End Laps: Weld top sheet in valley of side lap (through four sheet thicknesses) and again at middle of
sheet.
2. Intermediate Supports: Weld in X pattern. Weld in valley of side lap on every other joist and in valley of
center corrugation on remaining joists.
END OF SECTION
NAPA CENTURY CENTER XD 12
#165582