specs

SECTION 05320
METAL FLOOR DECK
PART 1 - GENERAL
1.01. SUMMARY
A. Section includes
1. Non-composite metal form deck.
1.02. REFERENCES
A. Steel Deck Institute, SDI, Specifications and Commentaries for Non-Composite Steel Form Deck.
B. American Iron and Steel Institute, AISI, Specification for the Design of Cold-Formed Steel Structural
Members.
C. American Welding Society:
1. AWS A5.1, Specification for Steel Carbon, Covered Arc Welding Electrodes.
2. AWS D1.3, Structural Welding Code - Sheet Steel.
D. American Society for Testing and Materials.
1. ASTM A1008, Standard Specification for Steel, Sheet, Cold-Rolled,Carbon, Structural.
2. ASTM A653, Standard Specification for Steel Sheet, Zinc-Coated (Galvanized) or Zinc-Iron Alloy-
Coated (Galvannealed) by the Hot-Dip Process.
3. ASTM A924, Standard Specification for General Requirements for Steel Sheet, Metallic-Coated by the
Hot-Dip Process.
1.03. SUBMITTALS
A. Shop Drawings: Submit installation drawings of metal floor deck showing layout and connections to
supporting structure.
B. Recycled Content:
1. Indicate recycled content; indicate percentage of pre-consumer and post-consumer recycled content per
unit of product.
2. Indicate material cost of product less labor included in project.
3. If recycled content product is part of an assembly, indicate the percentage of recycled content product in
the assembly by weight.
C. Local / Regional Materials:
1. Sourcing location(s): Indicate location of extraction, harvesting, and recovery; indicate distance between
extraction, harvesting, and recovery and the project site.
2. Manufacturing location(s): Indicate location of manufacturing facility; indicate distance between
manufacturing facility and the project site.
3. Product Value: Indicate dollar value of product containing local/regional materials; include materials cost
only.
4. Product Component(s) Value: Where product components are sourced or manufactured in separate
locations, provide location information for each component. Indicate the percentage by weight of each
component per unit of product.
D. Submit information on EPA Waste Minimization Priority Chemicals associated with products provided under
work of this Section. For each Priority Chemical, indicate whether the Priority Chemical is produced as a byproduct
during manufacture and whether it is contained in the final product. Indicate amount produced during
manufacture and the amount contained in final product in terms of percentage by weight per unit of product.
PART 2 - PRODUCTS
2.01. MATERIALS
A. Permanent Steel Forms: rib pattern high tensile steel forms capable of withstanding wet concrete weight plus
20 pounds per square foot with a maximum deflection of Span/120; uncoated, complying with Federal
Specification QQ-S-00640, full hard.
B. Welding Electrodes: AWS E60.
2.02. ENVIRONMENTALLY PREFERABLE PRODUCTS
A. To the greatest extent possible, provide products and materials that promote stewardship of the earth's
NAPA CENTURY CENTER XD 12
#165582