specs

SECTION 05200
STEEL JOISTS
PART 1 - GENERAL
1.01. SUMMARY
A. Section Includes:
1. Pre-engineered steel joists
2. Bridging
3. Ceiling extensions
4. Bearing plates
5. Side wall anchors
6. Extended ends
1.02. REFERENCES
A. Steel Joist Institute, SJI:
1. Standard Specifications for Open Web Steel Joists, K-Series; and Standard Load Table, Open Web Steel
Joists, K-Series.
2. Standard Specifications for Longspan Steel Joists LH Series; and Standard Load Table, Longspan Steel
Joists, LH Series.
3. Recommended Code of Standard Practice for Steel Joists and Joist Girders.
B. American Society for Testing and Materials:
1. ASTM A36, Standard Specification for Structural Steel.
2. ASTM A307, Standard Specification for Carbon Steel Externally Threaded Standard Fasteners.
C. American Welding Society:
1. AWS A5.5, Specification for Steel, Low-Alloy, Covered Arc Welding Electrodes.
2. AWS D1.1, Structural Welding Code - Steel.
1.03. SUBMITTALS
A. Shop Drawings: Submit shop and erection drawings to include member marks, number, type, location, and
spacing of members; details of bridging, extended ends and attachment at supports.
1. Reproductions of Contract Drawings shall not be used for shop drawings.
B. Design: Indicate on shop drawings where special designs have been provided, including a detailed written
description of magnitudes and locations of loads for each special design loading condition.
C. Submit Certified mill test reports showing compliance with requirements of ASTM and SJI Specifications.
D. Recycled Content:
1. Indicate recycled content; indicate percentage of pre-consumer and post-consumer recycled content per
unit of product.
2. Indicate material cost of product less labor included in project.
3. If recycled content product is part of an assembly, indicate the percentage of recycled content product in
the assembly by weight.
E. Local / Regional Materials:
1. Sourcing location(s): Indicate location of extraction, harvesting, and recovery; indicate distance between
extraction, harvesting, and recovery and the project site.
2. Manufacturing location(s): Indicate location of manufacturing facility; indicate distance between
manufacturing facility and the project site.
3. Product Value: Indicate dollar value of product containing local/regional materials; include materials cost
only.
4. Product Component(s) Value: Where product components are sourced or manufactured in separate
locations, provide location information for each component. Indicate the percentage by weight of each
component per unit of product.
F. Submit information on EPA Waste Minimization Priority Chemicals associated with products provided under
work of this Section. For each Priority Chemical, indicate whether the Priority Chemical is produced as a byproduct
during manufacture and whether it is contained in the final product. Indicate amount produced during
manufacture and the amount contained in final product in terms of percentage by weight per unit of product.
1.04. QUALITY ASSURANCE
A. Manufacturer Qualifications:
NAPA CENTURY CENTER XD 12
#165582