specs

Section 04100
Page 2
2. Product data. Unless otherwise indicated, submit the following for each type of product provided
under work of this Section:
1. Recycled Content:
a. Indicate recycled content; indicate percentage of pre-consumer and post-consumer
recycled content per unit of product.
b. Indicate relative dollar value of recycled content product to total dollar value of product
included in project.
c. If recycled content product is part of an assembly, indicate the percentage of recycled
content product in the assembly by weight.
d. If recycled content product is part of an assembly, indicate relative dollar value of
recycled content product to total dollar value of assembly.
3. Local/Regional Materials:
a. Sourcing location(s): Indicate location of extraction, harvesting, and recovery; indicate
distance between extraction, harvesting, and recovery and the project site.
b. Manufacturing location(s): Indicate location of manufacturing facility; indicate distance
between manufacturing facility and the project site.
c. Product Value: Indicate dollar value of product containing local/regional materials;
include materials cost only.
d. Product Component(s) Value: Where product components are sourced or manufactured
in separate locations, provide location information for each component. Indicate the
percentage by weight of each component per unit of product.
PART 2 - PRODUCTS
2.1 MATERIALS
A. Cement: ASTM C 150, Type I or II, low alkali; natural gray.
B. Hydrated Lime: ASTM C 207, Type S.
C. Quicklime: ASTM C 5.
D. Lime Putty: Made from hydrated lime or quicklime.
1. If made from quicklime, other than processed pulverized quicklime, slake lime and then screen
through a No. 16 mesh sieve. Before using, store and protect slaked and screened lime putty for
not less than 10 days.
2. Processed pulverized quicklime shall be slaked for not less than 48 hours, and shall be cool when
used.
3. Lime putty prepared from hydrated lime may be used immediately after mixing.
4. Lime putty prepared from quicklime or pulverized quicklime shall have a plasticity figure, after
slaking and screening, of not less than 200, and shall weigh not less than 83 lbs. per cubic foot.
Lime putty prepared from hydrated lime shall conform to ASTM C 207, Type S.
E. Aggregate:
1. For Mortar: ASTM C144.
2. For Grout: ASTM C404.
F. Admixture: “Sika Grout Aid”
G. Water: Suitable for domestic consumption.
2.2 MORTAR
A. Mortar shall be Type S having a 28 day compressive strength of not less than 1800 psi, and shall
conform to CBC Section 2103A.8.
B. Mortar shall be made with admixtures that are proportioned, added and mixed in strict accordance with
manufacturer's directions.
C. Mortar mix shall be proportioned by volume; one part portland cement, not less than 1/4 part nor more
than ½ part lime putty, and sand totaling not less than 2¼ nor more than 3 times sum of volumes of
cement and lime used.
1. Total clay content shall not exceed 2% of sand content or 6% of cement content.
NAPA CENTURY CENTER XD 12
#165582