specs

1.03. SUBMITTALS
Section 03300
Page 2
A. Product Data: submit manufacturers’ data indicating product compliance for the following:
1. Admixtures
2. Floor hardener
3. Curing compound
4. Curing and Sealing Compound
5. Vapor Retarder
6. Non-shrink grout
7. Waterstops
B. Material Certifications: submit certifications showing compliance for the following:
1. Fly ash.
2. Sieve analyses for structural concrete aggregates:
a. Coarse aggregate.
b. Fine aggregate.
C. Structural Concrete Mix Designs for each class of concrete
D. Concrete Delivery Tickets: Submit sample ready-mixed concrete delivery tickets in accordance with ASTM
C94 for each class of concrete.
E. Construction Joints: submit drawings indicating proposed locations of construction joints.
F. Recycled Content:
1. Indicate recycled content; indicate percentage of pre-consumer and post-consumer recycled content per
unit of product.
2. Indicate material cost of product less labor included in project.
3. If recycled content product is part of an assembly, indicate the percentage of recycled content product in
the assembly by weight.
G. Local / Regional Materials:
1. Sourcing location(s): Indicate location of extraction, harvesting, and recovery; indicate distance between
extraction, harvesting, and recovery and the project site.
2. Manufacturing location(s): Indicate location of manufacturing facility; indicate distance between
manufacturing facility and the project site.
3. Product Value: Indicate dollar value of product containing local/regional materials; include materials cost
only.
4. Product Component(s) Value: Where product components are sourced or manufactured in separate
locations, provide location information for each component. Indicate the percentage by weight of each
component per unit of product.
H. Submit information on EPA Waste Minimization Priority Chemicals associated with products provided under
work of this Section. For each Priority Chemical, indicate whether the Priority Chemical is produced as a byproduct
during manufacture and whether it is contained in the final product. Indicate amount produced during
manufacture and the amount contained in final product in terms of percentage by weight per unit of product.
1.04. QUALITY ASSURANCE
A. Batch Plant Qualifications - conform to the "Check List for Certification of Ready-Mixed Concrete Production
Facilities" of the National Ready-Mixed Concrete Association.
1.05. DELIVERY, STORAGE AND HANDLING
A. Transporting: Ready-mixed concrete supplier shall have sufficient capacity and adequate facilities to provide
continuous delivery at the rate required for continuous placement throughout any sequence of placement.
B. Storage of Materials
1. Store cement in weathertight buildings or bins which prevent intrusion of moisture or contaminants. Store
different types of cement in separate facilities.
2. Stockpile aggregates to prevent segregation and contamination with other materials. Thaw frozen
aggregates before use.
3. Sand shall be drained to a uniform moisture content before use.
4. Store admixtures securely to prevent contamination, evaporation, damage or temperature variation in
excess of the range recommended by the manufacturer.
C. Delivery: Truck mixers, agitators and non-agitating units shall conform to the applicable requirements of
ASTM C94, "Specification for Ready-Mixed Concrete".
NAPA CENTURY CENTER XD 12
#165582