specs

SECTION 03250
EMBEDDED METAL ASSEMBLIES AND INSERTS
PART 1 - GENERAL
1.01. SUMMARY
A. Section Includes:
1. Steel assemblies to be embedded into concrete
2. Anchors
3. Inserts
1.02. REFERENCES
A. Concrete Reinforcing Steel Institute, CRSI, Manual of Standard Practice.
B. American Institute of Steel Construction
1. AISC Specification for the Design, Fabrication and Erection of Structural Steel for Buildings.
C. American Welding Society, AWS:
1. D1.1, Structural Welding Code - Steel.
2. D1.4, Structural Welding Code - Reinforcing Steel.
D. American Concrete Institute:
1. ACI 318, Building Code Requirements for Reinforced Concrete.
2. ACI 315, Manual of Standard Practice for Detailing Reinforced Concrete Structures.
E. American Society for Testing and Materials:
1. ASTM A36, Standard Specification for Structural Steel.
2. ASTM A108, Standard Specification for Steel Bars, Carbon, Cold-Finished, Standard Quality.
3. ASTM A153, Standard Specification for Zinc Coating (Hot-Dip) on Iron and Steel Hardware.
4. ASTM A185, Standard Specification for Welded Steel Wire Fabric for Concrete Reinforcement.
5. ASTM A284, Standard Specification for Low and Intermediate Tensile Strength Carbon-Silicon Steel
Plates for Machine Parts and General Construction.
6. ASTM A307, Standard Specification for Carbon Steel Externally Threaded Standard Fasteners.
7. ASTM A325, Standard Specification for High-Strength Bolts for Structural Steel Joints.
8. ASTM A496, Standard Specification for Deformed Steel Wire for Concrete Reinforcement.
9. ASTM A570, Standard Specification for Hot-Rolled Carbon Steel Sheet and Strip, Structural Quality.
10. ASTM A615, Standard Specification for Deformed and Plain Billet-Steel Bars for Concrete
Reinforcement.
11. ASTM A706, Standard Specification for Low-Alloy Steel Deformed Bars for Concrete Reinforcement.
1.03. SUBMITTALS
A. Product Data: submit manufacturer's data indicating product compliance for the following:
1. Headed stud anchors
2. Deformed bar anchors
3. Rust inhibitor coating
4. Zinc coating
5. Lifting inserts
6. Threaded inserts
7. Anchor slots
B. Shop Drawings: submit shop and installation drawings showing shop and field connection details, including
material grades, material sizes, and details of fabrication.
1. Do not begin fabrication of materials prior to review of shop drawings.
2. Review of shop drawings is for member sizes, spacings, detail, and general compliance with Contract
Documents only.
3. Material quantities, lengths, fit, verification of job conditions, and coordination with other trades are
responsibility of Contractor.
C. Recycled Content:
1. Indicate recycled content; indicate percentage of pre-consumer and post-consumer recycled content per
unit of product.
2. Indicate material cost of product less labor included in project.
3. If recycled content product is part of an assembly, indicate the percentage of recycled content product in
the assembly by weight.
NAPA CENTURY CENTER XD 12
#165582