specs

SECTION 03200
CONCRETE REINFORCING
PART 1 - GENERAL
1.01. SUMMARY
A. Section Includes
1. Preparation of shop drawings
2. Fabrication and placement of reinforcing
1.02. REFERENCES
A. Codes and Specifications
1. American Concrete Institute:
a. ACI 318, Building Code Requirements for Reinforced Concrete.
b. ACI 315, Manual of Standard Practice for Detailing Reinforced Concrete Structures.
2. Concrete Reinforcing Steel Institute, CRSI, Manual of Standard Practice.
3. American Welding Society, AWS D1.4, "Structural Welding Code - Reinforcing Steel"
4. American Society for Testing Materials (ASTM)
a. ASTM A185, Standard Specification for Welded Steel Wire Fabric for Concrete Reinforcement.
b. ASTM A615, Standard Specification for Deformed and Plain Billet-Steel Bars for Concrete
Reinforcement.
c. ASTM A706, Standard Specification for Low-Alloy Steel Deformed Bars for Concrete
Reinforcement.
1.03. SUBMITTALS
A. Shop Drawings
1. Submit shop and installation drawings for review by Architect, including:
a. Sizes and quantities of reinforcing
b. Reinforcing lengths and details of bending
c. Placement instructions
d. Details and spacing of supports for reinforcing
e. Reference Engineer's reinforcing designations
f. Reproduce Engineer's notes regarding placement of reinforcing.
2. Review of Shop Drawings will be for reinforcing sizes, spacings, and general detail only, excluding
quantities, lengths and fit of materials.
3. Reproductions of Contract Drawings shall not be used for shop drawings.
B. Quality Control Submittals
1. Submit certified copies of mill reports, evidencing compliance with requirements of Specifications.
2. Submit copies of laboratory testing and inspection reports.
C. Recycled Content:
1. Indicate recycled content; indicate percentage of pre-consumer and post-consumer recycled content per
unit of product.
2. Indicate material cost of product less labor included in project.
3. If recycled content product is part of an assembly, indicate the percentage of recycled content product in
the assembly by weight.
D. Local / Regional Materials:
1. Sourcing location(s): Indicate location of extraction, harvesting, and recovery; indicate distance between
extraction, harvesting, and recovery and the project site.
2. Manufacturing location(s): Indicate location of manufacturing facility; indicate distance between
manufacturing facility and the project site.
3. Product Value: Indicate dollar value of product containing local/regional materials; include materials cost
only.
4. Product Component(s) Value: Where product components are sourced or manufactured in separate
locations, provide location information for each component. Indicate the percentage by weight of each
component per unit of product.
E. Submit information on EPA Waste Minimization Priority Chemicals associated with products provided under
work of this Section. For each Priority Chemical, indicate whether the Priority Chemical is produced as a byproduct
during manufacture and whether it is contained in the final product. Indicate amount produced during
NAPA CENTURY CENTER XD 12
#165582