specs

Section 01811
Page 2
E. Coordinate trades in accordance with the requirements in The General Conditions and General
Requirements of the construction contract.
F. Permit and provide access to locations of installed systems, subsystems, and components for
testing and inspection.
G. Review test procedures to ensure feasibility, safety and equipment protection and provide
necessary written limits to be used during tests.
H. Address current Designer and Owner punch list items before functional testing.
I. Provide schedule and perform field quality control tests and inspections required by the Contract
Documents and product manufacturers to BECA.
1. Update schedule biweekly throughout the construction period.
J. Provide field quality control testing and inspections on exterior enclosure construction (including
filling out commissioning checklists) and submit reports to the BECA.
K. Participate in testing/inspection procedures meetings.
l. Correct deficiencies as interpreted by the BECA, Designer, and Owner.
M. Reimburse Owner for non-compliant and/or failed tests and inspections as outlined in Divisions 01
through 14.
N. Address current BECA, Owner, and Designer punch list items.
O. During construction, maintain as-built red line drawings for all drawings and final CAD as-builts.
P. Coordinate with manufacturers to determine specific requirements to maintain the validity of the
warranty.
Q. Provide input for final commissioning documentation to the BECA.
R. Submit operation and maintenance data for systems, subsystems, and components to the BECA.
S. Participate in maintenance orientation, training, and inspection.
1.5 DESIGNER RESPONSIBILITIES
A. Provide paper and electronic copies of Project drawings and specifications to the BECA.
B. Provide written responses to design review comments from the BECA or other parties as
requested.
C. Attend design, pre-construction, and construction phase coordination meetings.
D. Participate in testing/inspection procedures meetings.
E. Provide resolution for items for which the BECA and Contractor may be in disagreement.
1.6 BUILDING ENVELOPE COMMISSIONING AUTHORITIES RESPONSIBILITIES
The BECA shall begin Work in the Pre-Design or Design Phases and continue until all building enclosure
systems have been accepted by both the Designer and the Owner. The specific tasks/responsibilities of the
BECA include the following:
A. Attend initial team meeting.
B. Evaluate design concepts against OPR and Architect’s BOD.
C. Incorporate commissioning requirements into the construction documents via a commissioning
specification.
D. Initial review of preliminary construction documents against OPR and BOD.
E. Perform back check review of construction documents against OPR and BOD.
F. Develop functional test plan for exterior enclosure.
G. Develop quality control checklists.
H. Review of Project drawings and specifications at 50%, and 100% completion for constructability,
durability, and performance of exterior enclosure conformance.
I. Review of pertinent building enclosure shop drawings/submittals for compliance with Contract
Documents.
J. Observe the construction and testing of mock-up(s).
K. Document construction of commissioned components at the completion of mock-up testing.
L. Design the exterior enclosure Commissioning Plan.
M. Attend preconstruction conferences.
N. Finalize Commissioning Plan.
O. Attend pertinent progress meetings (as needed).
NAPA CENTURY CENTER XD 12
#165582