Buffalo Wild Wings

Buffalo Wild Wings
C. (PT) Preservative Pressure Treated Lumber, Above Grade: AWPA Use Category UC3B,
Commodity Specification A (Treatment C2) using waterborne preservative to 0.25 lb/cu ft
retention.
1. Kiln dry lumber after treatment to maximum moisture content of 19 percent.
2. Treat lumber in contact with roofing, flashing, or waterproofing.
3. Treat lumber in contact with masonry or concrete.
PART 3 EXECUTION
3.01 INSTALLATION
A. Set rough carpentry to required levels and lines, with members plumb, true to line, cut, and
fitted. Fit rough carpentry to other construction; scribe and cope as needed for accurate fit.
Locate furring, nailers, blocking, grounds, and similar supports to comply with requirements for
attaching other construction.
B. Provide blocking and framing as indicated and as required to support facing materials, fixtures,
specialty items, and trim.
C. Select fasteners of size that will not fully penetrate members where opposite side will be
exposed to view or will receive finish materials. Make tight connections between members.
Install fasteners without splitting wood; do not countersink nail heads, unless otherwise
indicated.
D. Curb roof openings except where prefabricated curbs are provided. Form corners by alternating
lapping side members.
E. Coordinate curb installation with installation of decking and support of deck openings.
3.02 MEMBRANE UNDERLAYMENT INSTALLATION
A. Apply 1 layer of membrane underlayment over entire canopy area that is to receive aluminum
composite panels. Lap joints 6 inches.
3.03 SITE APPLIED WOOD TREATMENT
A. Apply preservative treatment compatible with factory applied treatment at site-sawn cuts,
complying with manufacturer's instructions.
B. Allow preservative to dry prior to erecting members.
END OF SECTION
04-27-11 ROUGH CARPENTRY
06100 -4