Buffalo Wild Wings

Buffalo Wild Wings
1.06 DELIVERY, STORAGE, AND HANDLING
A. Protect cold-formed metal framing from corrosion, deformation, and other damage during
delivery, storage, and handling.
B. Store cold-formed metal framing, protect with a waterproof covering, and ventilate to avoid
condensation.
1.06 PROJECT CONDITIONS
A. Verify that field measurements are as indicated on the drawings.
B. Coordinate work of this section with the placement of components within the stud framing
system.
PART 2 PRODUCTS
2.01 FRAMING SYSTEM
A. Provide primary and secondary framing members, bridging, bracing, plates, gussets, clips,
fittings, reinforcement, and fastenings as required to provide a complete framing system.
2.02 FRAMING MATERIALS
A. Studs and Track: ASTM C 955; studs formed to channel, "C", or "Sigma" shape with punched
web; U-shaped track in matching nominal width and compatible height.
1. Gage and depth: As indicated on the drawings.
2. Galvanized in accordance with ASTM A 653/A 653M G90/Z275 coating.
B. Joists and Purlins: Fabricated from ASTM A 653/A 653M steel sheet, with G90/Z275 hot dipped
galvanized coating.
1. Gage and depth: As indicated on the drawings.
2.03 ACCESSORIES
A. Bracing, Furring, Bridging: Formed sheet steel, thickness determined for conditions
encountered; finish to match framing components.
B. Plates, Gussets, Clips: Formed Sheet Steel, thickness determined for conditions encountered;
finish to match framing components.
C. Touch-Up Primer for Galvanized Surfaces: SSPC-Paint 20, Type I - Inorganic, complying with
VOC limitations of authorities having jurisdiction.
D. Sill Sealer: Closed-cell polyethylene foam, 1/4 inch thick, selected from manufacturer's
standard widths to match width of bottom track or rim track members.
2.04 FASTENERS
A. Self-Drilling, Self-Tapping Screws, Bolts, Nuts and Washers: Hot dip galvanized per ASTM A
153/A 153M.
B. Anchorage Devices: Power actuated and Drilled expansion bolts.
C. Welding: In conformance with AWS D1.1.
2.05 SHOP FABRICATED ASSEMBLIES
A. Shop fabricate metal framing to the greatest extent possible.
B. Fabricate cold-formed metal framing and accessories plumb, square, and true to line, and with
connections securely fastened, according to referenced AISI's specifications and standards,
manufacturer's written instructions, and requirements in this Section.
1. Fabricate framing assemblies using jigs or templates.
2. Cut framing members by sawing or shearing; do not torch cut.
04-27-11 COLD FORMED METAL FRAMING
05400 -2