Buffalo Wild Wings

SECTION 16470 - PANELBOARDS
PART 1. - GENERAL
1.1 SUMMARY
A. Section Includes: Provide panelboards wherever required by the Drawings and
Specifications.
1.2 SYSTEM DESCRIPTION
A. Circuit Numbers: Circuit numbers shown on Drawings shall be used for reference only.
Actual connections shall be in accordance with phasing of cabinet, load balance and
common neutral requirements.
B. Contractor shall contact local power utility anc coordinate all service requirements and
pay all associated fees and charges.
1.3 SUBMITTALS
A. Shop Drawings: Provide Shop Drawings in accordance with Section 16010.
1.4 QUALITY ASSURANCE
A. Regulatory Requirements: Construct panelboards to NEMA and Underwriters’
Laboratories (UL) standards.
PART 2. - PRODUCTS
2.1 MANUFACTURERS
A. Acceptable Manufacturers: All panelboards shall be as follows:
2.2 COMPONENTS
1. AMP (Cutler-Hammer Components)
2. Cutler-Hammer
3. EMI (Cutler-Hammer Components)
4. General Electric
5. Siemens-ITE
6. Square D
7. States Electric
A. General Requirements: Panelboards shall be dead front safety type and shall be UL
listed.
B. Enclosures: Enclosures shall be constructed of code grade steel with concealed trim
clamps and hinges. Panel front shall be lockable with all panels throughout the Project
keyed alike. Provide two keys for each panel.
C. Lugs: Solderless lugs only shall be provided in mains, unless otherwise noted on the
Drawings and/or the Panelboard Schedule. Main lugs shall be suitable for both 60-
degree- C and 75-degree-conductors. Main and neutral lugs shall be compression type.
Provide sufficient number of lugs to individually terminate each conductor.
PANELBOARDS
16470-1