Buffalo Wild Wings

D. Where locations shown or mounting heights specified for devices conflict with other
trades or building finishes, the Contractor shall coordinate exact requirements prior to
installation and install only after the approval of all involved.
E. Provide spacers as required between outlet boxes and devices so that each device is
flush with the finished wall. Plate screws shall not be used to stabilize device.
F. Location:
3.2 MOVING DEVICES
1. Switches near doors shall be located on side opposite the hinges (verify door
swings with Architectural Drawings before installation) and close to door trim.
Edge of switch plate shall be within six inches of door frame.
A. The Owner, through the Architect/Engineer, reserves the right to move any device a
distance of ten feet in any direction from the location shown on the Drawings without an
increase in Contract amount. This requirement shall only apply to devices before
installation.
B. In the event that an outlet shown on the Drawings will not be able to serve the specified
piece of equipment, the outlet shall be relocated as required, with no increase in contract
amount.
END OF SECTION 16140
WIRING DEVICES
16140-3