Buffalo Wild Wings

B. The Contractor shall procure all necessary certificates and permits and pay all required
fees. The Contractor shall pay all fees and installation charges by the utility company for
the permanent services.
C. Codes and Ordinances: All work and materials shall meet the requirements of national,
state and local codes and ordinances, in every respect. This requirement shall not relieve
the Contractor from meeting the requirements of Drawings and Specifications that may
be in excess of all codes and ordinances and not contrary to them. Following is a partial
list of governing codes and/or standards.
1. Occupational Safety & Health Act (OSHA)
2. Underwriters Laboratories (UL)
3. State and Local Building Codes
4. State Board of Health
5. State Industrial Commission
6. State and Local Fire Codes and Regulations
7. National Electric Code
8. State and Local Electrical Installation Codes
9. Local Power Company Regulations and Requirements
D. Inspections: Regular inspections shall be requested by the Electrical Contractor to meet
all state and local requirements. Contractor shall furnish a certificate of final inspection
and approval from all enforcement agencies to the Owner.
1.8 OPERATION AND MAINTENANCE MANUALS
A. The Electrical Contractor shall deliver two sets of Operation and Maintenance (O&M)
manuals to the Engineer prior to final close out. O&M manuals shall consist of approved
shop drawings, manufacturer’s bulletins, equipment manuals, a list of manufacturers with
telephone numbers for all equipment that contains replaceable parts and all other data
covering the care, maintenance and operation of each piece of furnished equipment.
O&M manuals shall be neatly bound in 3-ring binders, contain an index and section tabs
and be labeled with the Project name.
B. Name, address, and telephone number of Electrical Contractor and each associated
SubContractor installing equipment and systems, local representative for each item of
equipment and each system. Table of contents shall correspond to the Specifications
with the Section tab sheets placed before the respective Shop Drawings and operation
and maintenance instructions. Warranties for more than 1 year shall be included in
appropriate section.
1.9 OPERATING INSTRUCTIONS AND TESTING
A. The Contractor shall fully instruct the Owner in the operation of electrical equipment prior
to final close out. Contractor shall provide, without additional expense to Owner, services
of competent instructors who will give full instruction in the care, adjustment, operation
and maintenance of all electrical systems provided by this Contractor to Owner’s
permanent employees. Instructor shall be thoroughly familiar with all parts of the
installation that they are to give instructions and shall be trained in operating theory, as
well as in practical operation and maintenance work. Factory trained instructors shall be
employed wherever they are available. Instruction shall be given during regular work
week and at a time just prior to the time the equipment is accepted and turned over to
Owner for regular operation.
GENERAL CONDITIONS
16010-6