Buffalo Wild Wings

SECTION 15400 - PLUMBING SPECIALTIES
PART 1. - GENERAL
1.1 SUMMARY
A. Contractor shall provide all labor and materials to provide a complete plumbing and fuel
system for all fixtures and equipment shown on drawings. Contractor shall rough-in and
make final connections to all fixtures and appliances supplied by others.
B. Contractor shall thoroughly review the manufacturer’s installation instructions prior to
installing any piece of equipment or its associated service, (domestic drains, water piping,
etc.). Any conflicts between the manufacturer’s installation instructions and the plans or
specification shall be brought to the engineer at once for clarification. Contractor will not
receive additional money for installations requiring modifications due to these conflicts.
C. All plumbing systems shall meet State and Local codes as well as ADA requirements
regardless of information shown within the documents.
D. Gas Service: Make arrangements with the local gas company and pay all costs and fees
for firm gas service including gas meter with shut off valve on each side of the meter.
Verify exact location of gas meter and provide a gas shut off valve at the first accessible
point within the building. Provide a gas pressure regulator and shut off valve in an easily
accessible location at each appliance or unit of equipment as required and identify valve.
Vent gas pressure regulators per code. Coordinate with all gas firing equipment including
equipment supplied by others for gas pressure compatibility with the gas company.
Contractor to provide gas company with a list of gas fired equipment and requirements.
Coordinate gas pipe locations with all other trades.
E. Water Service:
1. Connect to Landlord provided 2” domestic water connection as shown on the
plans. Provide backflow prevention at the Landlord connection. Provide shutoff
valves at the connection point if not provided, (existing), by the Landlord. Verify
the exact location of the Landlord connection in the field.
F. Sanitary Service:
1. Sanitary: Provide sanitary piping to Landlord provided sanitary main as shown
on plans. Verify the exact location of the Landlord main prior to installing any
piping.
G. Grease Waste Connection:
1. Provide grease waste connection to the grease interceptor located outside of the
building. Provide piping back from the grease interceptor to the Landlord
provided waste connection. Provide all vent piping for grease interceptor. Refer
to plans for the location of the grease interceptor.
10/28/11 PLUMBING SPECIALTIES
15400-1