Buffalo Wild Wings

Buffalo Wild Wings
B. Hinges: BHMA 156.1, butt type, ball bearing, non-removable pin on exterior outswinging doors.
1. Hinge Size: 2 inch doors / 4-1/2 inches x 4-1/2 inches.
2. Finish: US26D for interior doors and US32D for exterior doors.
C. Exit Devices: BMHA 156.3, Grade 1.
1. Provide on exterior pairs of doors.
2. Keyed lock cylinder on outside of door by Section 08710.
3. Keyed dogging cylinders by Section 08710.
3. Finish: US26D.
4. Manufacturer: Von Duprin 99 Series with concealed vertical rods.
D. Push/Pull Set: BHMA 156.6.
1. Provide on each interior door and provide pull on exterior of exterior pair of doors.
2. Finish: US32D.
3. Note: Coordinate and match Pull design on projects that have existing mall hardware
design and finish.
E. Closers: Universal mounting and multi-sized modern surface type with full cover, sized for
individual door sizes and locations, (unless other types are required by special conditions.
1. Provide 110 degree arm.
2. Provide with cushion stop for exterior doors.
3. Finish: AL.
F. Weatherstripping: Wool pile, continuous and replaceable; provide on all exterior doors.
1. Finish: AL.
G. Sill Sweep Strips: Resilient seal type, of neoprene; provide on all exterior doors.
1. Finish: AL.
H. Threshold: ADA compliant extruded aluminum, one piece per door opening, ribbed surface;
provide on all exterior doors.
1. Finish: AL.
2.06 FABRICATION
A. Fabricate components with minimum clearances and shim spacing around perimeter of
assembly, yet enabling installation and dynamic movement of perimeter seal.
B. Accurately fit and secure joints and corners. Make joints flush, hairline, and weatherproof.
C. Prepare components to receive anchor devices. Fabricate anchors.
D. Coat concealed metal surfaces that will be in contact with cementitious materials or dissimilar
metals with bituminous paint.
E. Arrange fasteners and attachments to conceal from view.
F. Reinforce components internally for door hardware.
G. Reinforce framing members for imposed loads.
H. Finishing: Apply factory finish to all surfaces that will be exposed in completed assemblies.
1. Touch-up surfaces cut during fabrication so that no natural aluminum is visible in
completed assemblies, including joint edges.
PART 3 EXECUTION
3.01 EXAMINATION
A. Verify dimensions, tolerances, and method of attachment with other work.
B. Verify that wall openings and adjoining air and vapor seal materials are ready to receive work of
this section.
04-27-11 METAL-FRAMED STOREFRONTS
08410 -4