Buffalo Wild Wings

Buffalo Wild Wings
PART 3 EXECUTION
3.01 EXAMINATION
A. Verify that rough openings for door and frame are correctly sized and located.
3.02 INSTALLATION
A. Install units in accordance with manufacturer's instructions.
B. Install frames plumb and level in openings. Secure rigidly in place.
C. Position units to provide convenient access to the concealed work requiring access.
D. Provide shimming as necessary so that plaster screed is positioned to match thickness of
surrounding finish system.
E. Installation of surface mounted wall unit through adhered roofing membrane: Set flange in
continuous sealant. Provide weatherstrip on all edges and aluminum rain drip applied to top
edge.
F. Installation of panels in EIFS as applicable: Install prior to finish coat of EIFS.
3.03 INSTALLATION OF ENTRY CANOPY ACCESS PANEL
A. Install units in accordance with manufacturer's instructions.
B. Securely fasten access panel in wood frame opening. Set frame at height so that aluminum
composite panel infill will be flush with finished composite panel system of canopy.
C. Adhesively apply backer sheet of plywood and composite panel sheet in door recess.
Composite panel should set flush with canopy finish.
D. Coordinate installation of access panel with installation of composite panel system. Refer to
Section 07424 Aluminum Composite Panel System for specific panel system installed at
canopy.
END OF SECTION
04-27-11 ACCESS DOORS AND PANELS
08310 -2