Buffalo Wild Wings
Buffalo Wild Wings
Buffalo Wild Wings
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>Buffalo</strong> <strong>Wild</strong> <strong>Wings</strong><br />
2.02 ACCESSORIES<br />
A. Fasteners: Galvanized steel, with soft neoprene washers.<br />
B. Primer: Zinc chromate type.<br />
C. Protective Backing Paint: Zinc alkyd.<br />
D. Sealant: (SLNT6) specified in Section 07900.<br />
E. Bituminous Plastic Cement: ASTM D 4586, Type I. Verify compatibility with roofing membrane<br />
2.03 REGLETS<br />
A. Reglets: Recessed and surface mounted types for concrete and unit masonry applications; 26<br />
gauge galvanized steel.<br />
1. Recessed Reglet: Type MA reglet with Springlok Flashing.<br />
2. Surface Mounted Reglet: Type SM reglet with Springlok Flashing and 7/8” diameter,<br />
stainless steel washers with neoprene facing.<br />
B. Acceptable Manufacturers and Product:<br />
1. Fry Reglet Corporation: Springlok Reglets and Flashing System.<br />
2.04 FABRICATION<br />
A. Form sections true to shape, accurate in size, square, and free from distortion or defects.<br />
B. Form pieces in longest possible lengths.<br />
C. Hem exposed edges on underside 1/2 inch; miter and seam corners.<br />
D. Form material with flat lock seams, except where otherwise indicated. At moving joints, use<br />
sealed lapped, bayonet-type or interlocking hooked seams.<br />
E. Fabricate corners from one piece with minimum 18 inch long legs; seam for rigidity, seal with<br />
sealant.<br />
F. Fabricate vertical faces with bottom edge formed outward 1/4 inch (6 mm) and hemmed to form<br />
drip.<br />
G. Fabricate flashings to allow toe to extend 2 inches over roofing gravel. Return and brake edges.<br />
2.05 SCUPPER FABRICATION<br />
A. Scuppers: Fabricate to dimensions and configurations shown on the Drawings.<br />
B. Seal metal joints.<br />
2.06 MULTI-PIPE ROOF PENETRATIONS<br />
A. Fabricate hooded sheet metal enclosure at multiple roof penetrations. Do not use pitch pockets.<br />
1. Fabricate enclosure of proper size to accommodate pipes, insulation and necessary work<br />
clearances.<br />
2. Pipe penetrations shall be through the side of the exterior of the enclosure and shall occur<br />
a minimum of 8 inches above the roof membrane.<br />
3. Provide sloping sheet metal top on enclosure with hemmed drip edges on all sides and<br />
extended overhang a minimum of 6 inches on the side where pipe penetrations occur.<br />
4. Coordinate with Section 06100 for required curbing.<br />
PART 3 EXECUTION<br />
3.01 EXAMINATION<br />
A. Verify roof openings, curbs, pipes, sleeves, ducts, and vents through roof are solidly set, reglets<br />
in place, and nailing strips located.<br />
04-27-11 SHEET METAL FLASHING AND TRIM<br />
07620 -2
Change language